Cisco ASR 5000 Series Manual - Page 10

Browse online or download pdf Manual for Network Hardware Cisco ASR 5000 Series. Cisco ASR 5000 Series 12 pages.

Print Page
Cisco ASR 5000 Series Manual
Cisco NCS 5064
Ports
Figure 9: Cisco NCS 5604 Port Label
• 64 QSFP28 ports with the capability of operating at 100G and 40G rates.
• Ports 0-15 also support dynamic breakout with these combinations: 4x10G, 4x25G, and 2x50G.
• Ports 48-63 may also support MACsec in a future release.
• 2 x 10GE SFP+ ports (although physically present, these are not supported by IOS-XR).
Configure Breakout
Log into the router in the config mode, and type the following command (in this example, the breakout optics
is inserted in port 0):
RP/0/RP0/CPU0:router(config)# controller optics 0/0/0/0 breakout 4x10
RP/0/RP0/CPU0:router(config)# controller optics 0/0/0/0 breakout 4x25
RP/0/RP0/CPU0:router(config)# controller optics 0/0/0/0 breakout 2x50
Note
• The broken out QSFP interface will be named as following, depending on the break out mode:
• 4x10G: TenGigE 0/0/0/0/0, TenGigE 0/0/0/0/1, TenGigE 0/0/0/0/2, and TenGigE 0/0/0/0/3
• 4x25G: TwentyFiveGigE 0/0/0/0/0, TwentyFiveGigE 0/0/0/0/1, TwentyFiveGigE 0/0/0/0/2, and
• 2x50G: FiftyGigE 0/0/0/0/0, FiftyGigE 0/0/0/0/1
• The above commands fail if the optics inserted do not support breakout.
• The commands succeed if there are no optics inserted, and the breakout is executed whenever optics are
inserted at a later stage.
• For 4x10 breakout, copper and non-copper optics are also supported.
For 4x10 breakout, the supported optics type are : 40G SR4, 40G LR, 40G AOC, 40G PSM, 40G AC
(active copper), and 40G CR4 (passive copper).
Features
The Cisco NCS 5064 router has the following features:
Overview
10
TwentyFiveGigE 0/0/0/0/3
Overview