Cisco ASR 901S Series Preparing To Install - Page 4
Browse online or download pdf Preparing To Install for Network Hardware Cisco ASR 901S Series. Cisco ASR 901S Series 9 pages.
Also for Cisco ASR 901S Series: Troubleshooting (4 pages)
Print Page
Prerequisites
IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each warning
to locate its translation in the translated safety warnings that accompanied this device. Statement 1071
Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement
Warning
1001
Installation of the equipment must comply with local and national electric codes. Statement 1074
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
This unit is intended for installation in restricted access areas. A restricted access area can be accessed
Warning
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Class 1 laser product. Statement 1008
Warning
Warning
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of 149°F (65°C). Statement 1047
Prerequisites
Before installing the Cisco ASR 901S Series Aggregation Services Router, it is important to prepare for
installation by :
• Preparing the site (site planning) and reviewing the installation plans or method of procedures (MOPs).
• Unpacking and inspecting the Cisco ASR 901S Series Aggregation Services Router.
Site Planning
Ideally, you should have prepared the installation site beforehand. As part of your preparation, obtain a plan
of the site and the exact location where the Cisco ASR 901S Series Aggregation Services Router would be
housed. Determine the location of any existing routers and their interconnections, including communications
and power.
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
4
Preparing to Install the Router
OL-29732-02