Cisco ASR 9922 Manual - Page 14
Browse online or download pdf Manual for Network Hardware Cisco ASR 9922. Cisco ASR 9922 44 pages. Replacing cisco asr 9000 series router components
Print Page- 1. Field Replaceable Units
- 2. Online Insertion and Removal
- 3. Powering off the Router
- 4. Replacing the Chassis Air Filter
- 5. Required Tools and Equipment
- 6. Removing a Fan Tray
- 7. Installing a Fan Tray
- 8. Disconnecting AC Power
- 9. Reconnecting AC Power
- 10. Disconnecting DC Power
- 11. Reconnecting DC Power
Removing a Version 1 AC or DC Power Module
Example:
start update CBC eeprom, offset = 0x0,length=1000
..............................................................
done update CBC eeprom
start update I2C eeprom
...............................................................
done update I2C eeprom
The power system programming change is complete. The system must now be completely powered
down, and the NEW power system hardware installed. When the system is rebooted the software
will recognize the new power system. Please power down the system at this point.
#
Step 6
Remove the old power module (see
a Version 2 or Version 3 AC or DC Power
Caution
Step 7
Install the new power module (see
a Version 2 or Version 3 AC or DC Power Module, on page
Caution
Step 8
Power up the chassis.
Step 9
Verify that the (green) Power Input indicator on the front of the power module goes on. If the indicator does
not light, see
Removing a Version 1 AC or DC Power Module
Follow these steps to remove a version 1 AC or DC power module from the power tray (figure below).
Procedure
Step 1
Push the door latch to the left to release the door.
Step 2
Pivot the door to the right to eject the power module from its bay.
Step 3
Slide the power module out of its bay while supporting it with your other hand.
Caution
Replacing Cisco ASR 9000 Series Router Components
14
Removing a Version 1 AC or DC Power Module, on page 14
Use two hands to remove the power module. The power supply weighs about 6.5 pounds (2.95 kg).
Installing a Version 1 AC or DC Power Module, on page 16
To prevent damage to the power tray backplane connector, do not use excessive force when inserting
the power module into the power tray.
Troubleshooting the Power Subsystem
Use two hands to remove the power module. The power supply weighs about 6.5 pounds (2.95 kg).
Replacing Cisco ASR 9000 Series Router Components
Module).
16).
.
or
Removing
or
Installing