Cisco C8510MSR-SKIT-DC - Catalyst 8510 Multiservice Switch Router Getting Started - Page 6

Browse online or download pdf Getting Started for Network Hardware Cisco C8510MSR-SKIT-DC - Catalyst 8510 Multiservice Switch Router. Cisco C8510MSR-SKIT-DC - Catalyst 8510 Multiservice Switch Router 16 pages. Getting started

Print Page

iii Slide out the blade or blanking blade.

Open both retaining latches on the front of the MCU MSE 8510. When open, a

retaining latch is at a 90

Slide the MCU MSE 8510 into the blade slot (as shown in Figure 2) until it

stops.

Simultaneously close both retaining latches on the blade (thereby engaging the

connectors at the rear of the blade) to secure in the chassis as shown in Figure 3.

Using a No.1 Phillips screwdriver, tighten the screws in the retaining latches

with a clockwise quarter turn.The power is connected automatically as soon as

you close the latches. The LCD panel displays messages as parts are checked and

eventually you see "Waiting for application to boot" after which the Cisco logo

appears followed by the IP address allocated to the MCU MSE 8510.

Figure 2: Inserting a blade into the chassis

angle perpendicular to the front of the blade.

Installing the MCU MSE 8510