Cisco CE 2000 Platform SCE 2000 4xGBE Quick Start Manual - Page 13

Browse online or download pdf Quick Start Manual for Network Hardware Cisco CE 2000 Platform SCE 2000 4xGBE. Cisco CE 2000 Platform SCE 2000 4xGBE 29 pages. Service control engine

Print Page

Connecting Management Interfaces and Performing Initial System

Configuration

This section explains how to connect the SCE 2000 platform to a local console and how to cable the 10/100/1000 Ethernet

management interface.

Connecting the Local Console

You must first connect the unit to a local console and configure the initial settings for the SCE 2000 to support remote

management.

Make sure that the terminal configuration is as follows:

• 9600 baud

• 8 data bits

• No Parity

• 1 stop bits

• No flow control

The above Cisco SCE 2000 port parameters are fixed and are not configurable.

Plug the RS-232 serial cable provided with the Cisco SCE 2000 into the Con port on the front panel of the SCE 2000

Step 1

(#2 in Figure 14).

Figure 14

Connecting the Local Console to the SCE 2000 CON Port

S C E 8 0 0 0

Step 2

Connect the other end of the serial cable (with an attached DB-9 connector) to the VT100 compatible local (serial)

terminal.

Make sure that the Cisco SCE 2000 is powered on and has completed booting (this process may take several minutes).

Step 3

Press Enter several times until the Cisco logo appears on the local terminal and the setup configuration dialog begins.

Step 4

--- System Configuration Dialog ---

At any point you may enter a question mark '?' followed by 'Enter' for help.

Use ctrl-C to abort configuration dialog at any prompt.

Use ctrl-Z to jump to the end of the configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to continue with the System Configuration Dialog? [yes/no]: y

Step 5

Type y and press Enter.

Enters the system configuration dialog.

-S C M -E

O P T IC A

B Y P A S

S 1

C O N S O

L E

P O R T 1

1 0 /1 0 0 /

1 0 0 0

L IN K /

A C T IV E