Digitrax DN163A1 User Manual - Page 2
Browse online or download pdf User Manual for Media Converter Digitrax DN163A1. Digitrax DN163A1 8 pages. N scale mobile decoder
Print PageP P a a r r t t s s L L i i s s t t
1 DN163A1 Decoder
I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n
See the Digitrax Decoder Manual for complete decoder test procedures, instal-
lation instructions, programming and technical information. Digitrax manuals
and instructions are updated periodically. Please visit www.digitrax.com for the
latest versions, technical updates and additional locomotive-specific installation
instructions.
I I n n s s t t a a l l l l a a t t i i o o n n I I n n s s t t r r u u c c t t i i o o n n s s - - A A t t l l a a s s S S D D - - 6 6 0 0 L L o o c c o o m m o o t t i i v v e e
1. Carefully remove the
locomotive's shell from
the frame. Notice the ori-
entation of the light
board inside so that you
can install the decoder in
the same orientation.
2. Carefully remove the
plastic light shroud at the
front of the loco and
loosen the frame screws
enough to allow the
removal of the light
board. Lift the board out
of the frame.
3. Install the decoder, ,
between the frame halves
as shown. The narrow
part of the decoder fits
between the frame with
the frame clips holding
it at the corners of the
decoder cutout. The
brass motor contacts
should contact the
matching pads on the
bottom of the decoder
and be clear of the metal
frame. Squeeze the
frame halves together to
hold the decoder in
place.
4. Tighten the frame
©2009 Digitrax, Inc
D D
C C
i i g g i i t t r r a a x x
o o m m m m a a n n d d
R R u u n n Y Y o o u u r r T T r r a a i i n n s s , , N N o o t t Y Y o o u u r r T T r r a a c c k k ! !
Factory
Light board
Figure 1: Remove loco shell
Motor
contacts
Figure 2: Loosen frame screws
and remove light board
Figure 3:
Place decoder in frame.
www.digitrax.com
C C
o o n n t t r r o o l l
1 Instruction sheet
frame screws
frame clips
Light
shroud
2