argon audio tt-2 Owner's Manual - Page 6

Browse online or download pdf Owner's Manual for Turntable argon audio tt-2. argon audio tt-2 12 pages.
Also for argon audio tt-2: Owner's Manual (12 pages), User Manual (12 pages)

Print Page
argon audio tt-2 Owner's Manual
TT- 2

Setup and usage

In order to achieve maximum performance and reliability with this record player you should study these instructions for use
carefully.
The Argon Audio TT2 record player is supplied with a factory fitted and adjusted cartridge.
** The following instructions for adjusting the cartridge are provided in case the cartridge is replaced by a different model at a later
date.
During assembly and adjustment of the deck, small parts could be lost if not carefully placed in a suitable receptacle.
Before starting assembly make yourself acquainted with the parts listed above and correspondingly numbered in the technical
drawings above. Separately packed items are marked with an asterisk *.

Set-up

Make sure the surface you wish to use the turntable on is level (use a spirit level) before placing the turntable on it.
Remove the two red transport screws (1) which secure the motor (22) during transportation.
Fit the drive belt (3) around the hub (4) and the smaller diameter part of the motor pulley (2). Avoid getting sweat or grease on the
belt as these will deteriorate the performance and reduce the belt's lifespan. Use absorbent kitchen paper to remove any oil or
grease from the outer edge of the hub and the belt. Fit the platter (5) and felt mat over the spindle of the hub (4).
Store the two motor transport screws (1) in the original packaging so they are available for any future transportation.

Cartridge down force adjustment

The counterweight (6) supplied is suitable for cartridges weighing between 3,5 - 5,5g. An alternative counterweight for cartridges
weighing between 6 - 9g is available as an accessory part. Adjust the down force prior to installing the anti-skating weight.
Gently push and turn the counterweight (6) onto the arm tube stub. Lower the arm lift and position the cartridge in the space between
arm rest and platter. Carefully rotate the counterweight (6) until the arm tube balances out. The arm should return to the balanced
position if it is moved up or down. This adjustment must be done carefully. Do not forget to remove the cartridge protection cap if
fitted.
Once the arm is correctly balanced return it to the rest. Hold the counterweight (6) without moving it, and gently revolve the down
force scale ring (6a) until the zero is in line with the anti-skating prong (15). Check whether the arm still balances out.
Rotate the counterweight counter clockwise (seen from the front) to adjust the down force according to the cartridge
manufacturer's recommendations.
w w w . a r g o n a u d i o . c o m
6