Digitrax UP7 Quick Start Manual

Browse online or download pdf Quick Start Manual for Toy Digitrax UP7. Digitrax UP7 2 pages. Loconet universal pane

Print Page

UP7

LocoNet Universal Panel

Features:

▪

Simplifies hookup, maintenance and troubleshooting of LocoNet.

▪

All connections plug-detachable.

▪

Two RJ12 Throttle Jacks in front panel.

▪

One RJ12 LocoNet Jack on side of panel.

▪

Track Status Indicator LED option shows local track status if hooked up to a

track section.

▪

Two RJ12 LocoNet Jacks in rear for connection to other LocoNet devices.

Use with 6 conductor telephone cable with RJ12 6-pin connectors and daisy

chain your LocoNet ports around the layout.

▪

"Power sharing" charge Circuitry for throttles connected to six UP7's. (Ex-

ternal 12V supply required for this optional DT602/UT6 charging source in

sleep mode).

Parts List

1 UP7 Front Panel

1 Instruction Sheet

Panel Assembly

The UP7 is shipped with the front

panel unattached. Attach the panel

as oriented in Figure 1 prior to

installing the UP7 in your layout:

Unscrew the two #2 screws on the

faceplate rear tabs, insert the UP7

PCB. Screw back these two screws,

which then clamp the PCB horizon-

tally at the back of the panel.

UP7 Panel Installation

Inspect all the RJ12 Jacks have

6 parallel gold pins, with none

shorted to adjacent pins.

The UP7 Universal Panel is

designed for mounting on the

fascia board of the layout. Cut a hole approximately 2.6" w x 1.7" h in the

fascia board.

Insert the UP7 through the hole with the face plate on the front of the fascia

board. Retain the UP7 face plate to the fascia with four e.g. #6 screws of your

choice.

Hook up working LocoNet cables at the rear Jacks, and test operation is

satisfactory with e.g. a Throttle plugged into the front RJ12 Jacks.

Complete Train Control

Run Your Trains, Not Your Track!

Figure 1

— 1 —

1 UP7 PCB with 4pin plug

GND

www.digitrax.com

TKA

TKB