Digitron 2029T Quick Start Manual

Browse online or download pdf Quick Start Manual for Thermometer Digitron 2029T. Digitron 2029T 2 pages.

Print Page

Model:

Sensor:

Connector Type:

Units:

Operating Temperature:

Operating Range:

Accuracy of Unit Only:

Before Use

Please ensure this unit is suitable to application.

Check temperature range and thermocouple type to ensure suitability for application.

Power

The instrument requires two AA or equivalent cells. These are not supplied with the unit.

When the batteries require changing the following symbol will be displayed:

Please ensure the screws holding the battery compartment are firmly tightened when inserting or replacing batteries

to ensure the IP65 rating is maintained.

Press ON key to turn unit ON. Press OFF key to turn unit OFF.

The unit will switch OFF automatically after 12 minutes, unless any key is activated.

To disable automatic switch off, hold

switch-off function until the unit is switched off.

Hold Function

To enable the Hold Function, press the "Hold"

Speedread

This is a function that gives an indicative reading within 14 seconds for poor thermal conductivity items. The use of

this function will reduce the accuracy to ±2˚C. For correct Speedread measurements the probe must be in good

thermal contact with medium under test prior to activating the function. A steep temperature gradient or wide

temperature and item under test are required. Speedread is suitable for core frozen food measurements and

hot/cold liquids. Good thermal contact is unlikely when a general purpose or between pack probe is used on the

surface of food produce. (Not suitable for use with between pack probe).

Insert probe and press

appears and the

symbol will be displayed. This reading will automatically be held. Press

normal mode. If it is not possible to obtain a faster reading due to the similarity of probe tip temperature and the

temperature of item to be measured, then the

mode.

C/F˚C Selection

Select the desired temperature scale by pressing

display, and is retained when the instrument is switch off.

Range lock

All instruments have a 0.1˚ resolution from -199.9˚C to+199.9˚C and a 1˚ resolution outside this range. To fix the

display to a 1˚ resolution, press the A/R key. To cancel the mode, press the A/R key again and A/R will be shown on

the display.

Thermocouple selection

Ensure thermocouple is connected.

Press KTJNRS key to select the available type as shown by K, T, J, N, or S on the display.

This selection is retained.

2029T

K, T, J, N, R, S Thermocouple plug

2 pin mini plug

°C/°F

-10°C to +50°C

-200°C to +1600°C (Dependent on Thermocouple input)

± 1 Digit ( 0.1˚C Low scale; 1˚C High scale )

0.1% of reading ±0.2˚C above -100˚C

0.5% of reading ±0.2˚C below -100˚C

Key when the unit is being switched on. This will disable the automatic

key. The

symbol will appear and the display will flash fast until the correct reading

button

symbol will be cancelled and the instrument will return to normal

key. The selected scale is confirmed by ˚C or ˚F symbol on the

key to return to