Digitron Easy Lock DMI13PG/B/A User's Manual, Maintenance, Installation Manual - Page 3
Browse online or download pdf User's Manual, Maintenance, Installation Manual for Rfid Systems Digitron Easy Lock DMI13PG/B/A. Digitron Easy Lock DMI13PG/B/A 14 pages. Proximity lock rfid mifare 13,56 khz, bolt lenght - 13/18 mm
PERSONAL USE
1
It is possible program the lock so that it works with a specific personal TAG
( Card or Wristband ).
With the lock "open" lean the special READ FIXED card to the center of the sensor and
remove the card only when the the LED turns "ON".
Within 5 seconds ( before the LED turns "OFF" ) lean the personal compatible TAG
( Card or Wristband ) and remove the card only when the LED stays "ON" after has issued
short flashes.
After this procedure the lock will work only with the personal TAG ( Card or Wristband )
programmed.
Note : with the personal use mode when the lock is closed the led does not flashes
To return in the mode Shared Use :
With the lock "open" lean the special FIXED ERASED card to the centre of the sensor and
remove the card when the LED turns "ON".
After this procedure the lock closes with any compatible TAG ( Card or Wristband ) and
it will open only with the same TAG used to close
TIMER SETTING
By inserting the timer, the lock will open after an established time everytime it is closed.
To set the timer please follow the instruction below :
With the lock "open" lean the special TIMER with the value of the hours that you wish
to program to the center of the sensor and remove the card when the LED turns "ON".
When the lock is closed the LED will shortly flash 2 time every 2 seconds to indicate that
the lock is closed with the Timer "ON".
For disconnecting the Timer proceed as above and use the TIMER card with value "0".
PAG. 3