Cisco Performance Routing Engine 5 Hardware Installation Manual - Page 29

Browse online or download pdf Hardware Installation Manual for Network Hardware Cisco Performance Routing Engine 5. Cisco Performance Routing Engine 5 35 pages.
Also for Cisco Performance Routing Engine 5: Quick Start Manual (2 pages)

Print Page
Cisco Performance Routing Engine 5 Hardware Installation Manual
Description
Cable Holder for PRE5 in Redundant Modeling
Enhanced Fan Filter for the Cisco uBR10012 Router
Cable Management Kit for Redundant PRE5
10GBASE-ER SFP Module
10GBASE-LR SFP Module
10GBASE-LRM SFP Module
10GBASE-SR SFP Module
10GBASE-ZR SFP module
For more information about the 10GBase SFP modules, see the
1GB USB Flash Token, Spare
RJ45 Roll-over Cable (Special cable for the
Console/AUX port connection)
RJ45-DB9 Cable (this cable connects the
Console/AUX port on the PRE5 to the 9 pins D-type
RS232 port on a PC)
Cisco Dense Wavelength-Division Multiplexing
(DWDM) SFP Modules, Spare
1
A minimum configuration of 1 count of 10G license is required when purchasing the UBR10-PRE5 hardware.
2
For redundancy, it is strongly recommended to purchase the same license counts on the active and standby PREs to maintain
consistency.
3
In redundancy mode, cable management kit is required to facilitate fiber/cable routing and board to board connection (between
the active and standby PREs). Cable management kit includes 1 x cable holder (PRE5-CAB-HOLDER) and 4 x board to board
cables (CAB-PRE5-BTB).
4
For related caveat information, see the
Specifications
Description
Card dimension: height x width x depth
Weight
Power Consumption
Thermal heat Dissipation
Mean Time Between Failure (MTBF)
Temperature Range
Part Number
PRE5-CAB-HOLDER
UBR10-FAN-FILT-E
3
PRE5-HA-CBLMG-KIT
SFP-10G-ER
SFP-10G-LR
SFP-10G-LRM
SFP-10G-SR
4
SFP-10G-ZR
Cisco 10GBASE SFP+ Modules Data
MEMUSB-1024FT=
72-5454-01
72-5455-01
For part number information, see the
10GBASE Dense Wavelength-Division
Multiplexing SFP+ Modules Data
Cisco uBR10012 Router Release Notes for Cisco IOS Release
Specification
1.965" x 16.52" x 11.0381"
5.05 kg (11.134 lbs)
248 W (active PRE), 207 W (standby PRE)
248 W (active PRE), 207 W (standby PRE)
176330 hours at 40°C inlet temperature
Storage temperature: –38 to 150°F (–40 to 70°C)
Operating temperature, nominal: 41 to 104°F (5 to 40°C)
Operating temperature, short term: 23 to 122°F (–5 to 50°C)
Minimum Cisco IOS
Release
12.2(33) SCH
12.2(33) SCH
12.2(33) SCH
12.2(33) SCH1
12.2(33) SCH
12.2(33) SCH
12.2(33) SCH
12.2(33) SCH
Sheet.
12.2(33) SCH
12.2(33) SCH
12.2(33) SCH
Cisco
12.2(33) SCH1
Sheet.
12.2(33)SCH.
29