Cisco Prisma EtherLinX Installation Instructions Manual - Page 24
Browse online or download pdf Installation Instructions Manual for Network Hardware Cisco Prisma EtherLinX. Cisco Prisma EtherLinX 38 pages.
Print Page
SNMP Management,
• Command List
Command
I
P
T
K
C
U
D
E
Space
Notes:
• You must reboot after making any modifications to the Saved Values or your
changes will not take effect. To reboot, type reboot at the prompt on the main
configuration screen, or turn the chassis power OFF then ON again.
• Because a Delete key is not available on VT-100 terminal emulators; use the F2 key.
Assigning TCP/IP Information
Follow these steps to modify the Saved Parameter Values (i.e., assign IP address and
subnet mask).
1.
From the Main Configuration screen, press I.
2.
Enter the IP address for the connected device and press Enter.
3.
Enter the subnet mask for the connected device and press Enter.
4.
If desired, assign a default gateway
OR
to skip, press Enter.
5.
When finished, press Enter.
6.
Type reboot for changes to take effect.
Result: The Saved Values and Current Values should now both display the
changes made (e.g., new IP address and subnet mask).
24
Continued
Enter New Saved Parameter Values
Change Password
New Trap Destination
Remove ALL Trap Destinations
New Community String
Delete ALL Community Strings
Enable/disable DHCP
End Session
Device Specific Configuration options available here
Description
Continued on next page
4008226 Rev B