Cisco SCE 1000 and Quick Start Manual - Page 21

Browse online or download pdf Quick Start Manual for Network Hardware Cisco SCE 1000 and. Cisco SCE 1000 and 49 pages. Service control engine 1000 2xgbe

Print Page

Step 2

Enable or disable DNS lookup.

To enable DNS lookup, press Enter.

–

To disable DNS lookup, type

–

Enable IP DNS-based hostname translation? [yes]:

If you choose to disable DNS lookup, skip the rest of this section and go to Step 6: Configuring the RDR Formatter

Destination, page 21. The rest of the dialog is not presented, as it is irrelevant when DNS lookup is disabled.

Type the default domain name to be used, and press Enter.

Step 3

Note that there is no default domain name.

You may accept the default domain name or enter a new one.

Enter default domain name []:

Step 4

Configure the primary domain name server.

Type the IP address of the primary domain name server and press Enter.

Enter Primary DNS IP address:

Note that there is no default for this parameter.

Configure any additional domain name servers.

Step 5

You may configure up to three domain servers.

Would you like to add another Name Server? [no]:

To exit the DNS settings dialog, press Enter.

–

To add another domain server, type y and press Enter.

–

You are asked to enter the IP address of the next domain name server.

Enter Secondary DNS IP address:

Exit the dialog.

Step 6

When IP addresses for all servers have been entered, exit the dialog by pressing press Enter.

Would you like to add another Name Server? [no]:

Example:

Following is a sample DNS configuration dialog. The default domain name is pcube.com, and the IP address of the Domain

Name Server is 10.1.1.230.

Would you like to enter the DNS configuration menu? [no]: y

Enable IP DNS-based hostname translation? [yes]:

Enter default domain name []: pcube.com

Enter Primary DNS IP address: 10.1.1.230

Would you like to add another Name Server? [no]:

Step 6: Configuring the RDR Formatter Destination

The SCE 1000 passes Raw Data Records (RDRs) to an external collection system via the RDR-Formatter. In order for the data

to reach the correct location, the IP address of the external collection system and its port number must be configured.

Enter the RDR formatter configuration menu.

Step 1

Would you like to enter the RDR-formatter configuration menu? [no]: y

Type

and press Enter.

The RDR-formatter destination dialog begins.

and press Enter.