Cisco Secure Firewall 3120 Getting Started - Page 14

Browse online or download pdf Getting Started for Network Hardware Cisco Secure Firewall 3120. Cisco Secure Firewall 3120 42 pages.

Print Page

Cabling for the Firepower 1100

Figure 2: Cabling the Firepower 1100

• Connect your management computer to either of the following interfaces:

• Connect the outside network to the Ethernet1/1 interface (labeled WAN).

• Connect other networks to the remaining interfaces.

Getting Started

• Ethernet 1/2—Connect your management computer directly to Ethernet 1/2 for initial configuration,

or connect Ethernet 1/2 to your inside network. Ethernet 1/2 has a default IP address (192.168.95.1)

and also runs a DHCP server to provide IP addresses to clients (including the management computer),

so make sure these settings do not conflict with any existing inside network settings.

• Management 1/1 (labeled MGMT)—Connect your management computer to the management

network. The Management 1/1 interface obtains an IP address from DHCP, so make sure your

network includes a DHCP server.

If you need to change the Management 1/1 IP address from the default to configure a static IP

address, you must also cable your management computer to the console port. See

Management Network Settings at the CLI, on page

You can later configure management access from other interfaces.

By default, the IP address is obtained using IPv4 DHCP and IPv6 autoconfiguration, but you can set a

static address during initial configuration.

21.

Getting Started

(Optional) Change