Cisco TelePresence Server 7010 Installation Manual - Page 4
Browse online or download pdf Installation Manual for Network Hardware Cisco TelePresence Server 7010. Cisco TelePresence Server 7010 14 pages. 600w ac-input power supply and fan tray replacement
Also for Cisco TelePresence Server 7010: Replacement Instructions Manual (23 pages), Installation Instructions Manual (15 pages), Getting Started (16 pages), Replacement Instructions Manual (18 pages)
Print Page
General information
Figure 2: TelePresence Server 7010 rear panel
Air exhaust
1000
1000
100
100
FDX
FDX
Ethernet C
Ethernet A
Ethernet B
Ethernet ports and status LEDs
LED behavior
Front panel LED behavior
The following table describes the behavior of the LEDs on the front of the TelePresence Server.
Table 1: TelePresence Server 7010 front panel LED behavior
LED
Color
Status
Green The unit is operating normally
Alarm
Red
USB Activity
Rear panel Ethernet
Green Activity on rear panel Ethernet port A, B, C and D
activity
Rear panel LED behavior
The following table describes the behavior of the LEDs on the rear of the unit.
Note: The front panel LCD will show the IP address assigned.
Table 2: TelePresence Server 7010 rear panel LED behavior
LED
Color
Ethernet Port Status:
Cisco TelePresence Server 7010 Installation Guide
1000
1000
100
100
FDX
FDX
Ethernet D
Admin port and status LEDs
Indicates
The unit is booting or has developed a fault, for example:
temperature is outside normal limits
n
internal fan failure detected
n
See the web interface for more information about the problem (go to the
configuration page for your unit)
Reserved for future expansion
Indicates
Link connectors
100
10
Link
FDX
Admin
Link In
Link Out
Power supply latch
Protective earth terminals
OK
!
Link
Power supply
Page 4 of 14