Cisco UBR7246VXR Quick Start Manual - Page 9
Browse online or download pdf Quick Start Manual for Network Hardware Cisco UBR7246VXR. Cisco UBR7246VXR 27 pages. Universal broadband router
Also for Cisco UBR7246VXR: User Manual (7 pages), Installation Manual (28 pages), Hardware Installation (25 pages)
Print Page
Attach the Rack-Mount Brackets to the Rear of the Chassis
To install the rack-mount brackets on the chassis for a rear rack-mount configuration, complete the following steps:
Locate the threaded holes in the rear sides of the chassis.
Step 1
Align the first rack-mount bracket to the threaded holes in the right side of the chassis. See Figure 4.
Step 2
Figure 4
Installing the Rack-Mount Brackets on the Rear of the Chassis
Rack-mount
bracket
There are eight holes in each of the rack-mount brackets for the Cisco uBR7246VXR. You may use either set
Note
of four holes to align the bracket to the threaded holes in the sides of the chassis.
Thread the four M4 x 6-mm Phillips flathead screws through the rack-mount bracket and into the side of the chassis.
Step 3
Use a number 2 Phillips screwdriver to tighten the screws.
Step 4
Repeat Step 1 through Step 3 for the other rack-mount bracket.
Step 5
See the "Installing the Cable-Management Brackets" section on page 11 for cable management bracket instructions.
Attach the Rack-Mount Brackets to the Front of the Chassis
To install the rack-mount brackets on the chassis for a front rack-mount configuration, complete the following steps.
Locate the threaded holes in the front sides of the chassis.
Step 1
Step 2
If you want the front of the chassis flush with the front of the rack, align the first rack-mount bracket to the threaded
holes in the right side of the chassis as shown in Figure 5
If you want the front of the chassis protruding from the rack, align the first rack-mount bracket to the threaded holes
in the right side of the chassis as shown in Figure 6.
There are eight holes in each of the rack-mount brackets. You may use either set of four holes to align the bracket to
Note
the threaded holes in the sides of the chassis.
Thread the four M4 x 6-mm Phillips flathead screws through the bracket and into the side of the chassis. Use a
Step 3
number 2 Phillips screwdriver to tighten the screws.
Step 4
Repeat Step 1 through Step 3 for the other rack-mount bracket.
Rack-mount
bracket
9