Cisco 3500 Series Installation Manual - Page 21
Browse online or download pdf Installation Manual for Server Cisco 3500 Series. Cisco 3500 Series 36 pages.
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances
Figure 6: Front Securing Mechanism, Inside of Front End
1
Front mounting pegs
2
Rack post
Step 3
Install the outer slide rails into the rack:
a) Align one slide-rail assembly front end with the front rack-post holes that you want to use. The slide rail front-end
wraps around the outside of the rack post and the mounting pegs enter the rack-post holes from the outside-front (see
the figure above).
The rack post must be between the mounting pegs and the open securing plate.
Note
b) Push the mounting pegs into the rack-post holes from the outside-front.
c) Press the securing plate release button, marked PUSH. The spring-loaded securing plate closes to lock the pegs in
place.
d) Adjust the slide-rail length, and then push the rear mounting pegs into the corresponding rear rack-post holes. The
slide rail must be level front-to-rear.
The rear mounting pegs enter the rear rack-post holes from the inside of the rack post.
e) Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail assemblies are at
the same height with each other and are level front-to-back.
f) Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops and lock in place.
Step 4
Insert the server into the slide rails:
This server can weigh up to 67 pounds (59 kilograms) when fully loaded with components. We recommend
Caution
that you use a minimum of two people or a mechanical lift when lifting the server. Attempting this procedure
alone could result in personal injury or equipment damage.
Figure 7: Inner Rail Release Clip
3
Cisco Secure Network Server 3500 Series Appliance Hardware Installation Guide
Securing plate shown pulled back to open position
Install the Side Rails
17