Cisco 700 series Getting Started Manual - Page 23

Browse online or download pdf Getting Started Manual for Server Cisco 700 series. Cisco 700 series 27 pages. Using profiles
Also for Cisco 700 series: Quick Start Manual (8 pages), Overview (19 pages), User Manual (9 pages), Administration Manual (36 pages)

Print Page

Operation of Cisco Aironet Access Points in Brazil

This section contains special information for operation of Cisco Aironet access points in Brazil.

Access Point Models

AIR-CAP702I-T-K9

AIR-SAP702I-T-K9

Portuguese Translation

Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial, mesmo de

estações do mesmo tipo, e não pode causar interferência a sistemas operando em caráter primário.

English Translation

This equipment operates on a secondary basis and consequently must accept harmful interference, including interference from

stations of the same kind. This equipment may not cause harmful interference to systems operating on a primary basis.

Declaration of Conformity Statements

All the Declaration of Conformity statements related to this product can be found at the following location:

http://www.ciscofax.com

Configuring DHCP Option 43 and DHCP Option 60

This section contains a DHCP Option 43 configuration example on a Windows 2003 Enterprise DHCP server for use with Cisco

Aironet lightweight access points. For other DHCP server implementations, consult product documentation for configuring

DHCP Option 43. In Option 43, you should use the IP address of the controller management interface.

DHCP Option 43 is limited to one access point type per DHCP pool. You must configure a separate DHCP pool for

Note

each access point type.

The 700 series access point uses the type-length-value (TLV) format for DHCP Option 43. DHCP servers must be programmed

to return the option based on the access point's DHCP Vendor Class Identifier (VCI) string (DHCP Option 60). The VCI string

for the 700 series access point is:

Cisco AP c700

If your access point was ordered with the Service Provider Option (AIR-OPT60-DHCP) selected in the ordering tool,

Note

the VCI string for the access point contains ServiceProvider. For example, a 700 with this option will return this VCI

string:

Cisco AP c700-ServiceProvider

The format of the TLV block is listed below:

• Type: 0xf1 (decimal 241)

• Length: Number of controller IP addresses * 4

• Value: List of WLC management interfaces

To configure DHCP Option 43 in the embedded Cisco IOS DHCP server, follow these steps:

Enter configuration mode at the Cisco IOS CLI.

Step 1