Cisco 7513 Series Quick Start Manual - Page 11

Browse online or download pdf Quick Start Manual for Server Cisco 7513 Series. Cisco 7513 Series 44 pages. Chassis replacement
Also for Cisco 7513 Series: Replacement Instructions Manual (26 pages), Datasheet (11 pages), Manual (30 pages), Maintaining (20 pages), Replacement Instructions Manual (19 pages), Replacement Instructions Manual (22 pages)

Print Page

Install the Hardware

Install Interface Processors, Fillers, VIPs, or RSPs

Card

carrier

Captive

guide

installation

screw

The Route Switch Processor (RSP) comes uninstalled

with your Cisco 7513 or 7576 router, but is a

required system component. Install the RSP2, RSP4,

or RSP8 in either slot 6 or slot 7, and install interface

processors (optional) in any of the eleven interface

Bottom ejector lever

Card

slot

STOP!

on contact

processor slots, which are numbered 0 through 5,

and 8 through 12, from left to right when viewing

the chassis from the rear.

Step 1

Hold the interface processor, ﬁller, VIP, or

RSP with one hand, and place your other

hand under the carrier to support the card

and guide it into the slot. Avoid touching

the card.

Step 2

Place the interface processor, ﬁller, VIP, or

RSP in the slot and align the guide on the

carrier with the groove in the slot.

Step 3

Carefully slide the interface processor,

ﬁller, VIP, or RSP into the slot until the

faceplate makes contact with the ejector

levers.

Step 4

Use the thumb and foreﬁnger of each hand

to push the ejector lever ﬂat against the

interface processor, ﬁller, VIP, or RSP.

Step 5

Use a screwdriver to tighten the captive

installation screws.

Step 6

Repeat Step 1 through Step 5 to install

any additional interface processors, ﬁllers,

VIPs, or RSPs.

Step 7

To check an RSP installation, refer to the

"Check the RSP Installation" section on

page 28, and refer to the "Check the

Interface Processor or VIP Installation"

section on page 29 to check the interface

processor or VIP installation.