Cisco 7513 Series Replacement Instructions Manual - Page 9

Browse online or download pdf Replacement Instructions Manual for Server Cisco 7513 Series. Cisco 7513 Series 19 pages. Chassis replacement
Also for Cisco 7513 Series: Quick Start Manual (44 pages), Replacement Instructions Manual (26 pages), Datasheet (11 pages), Manual (30 pages), Maintaining (20 pages), Replacement Instructions Manual (22 pages)

Print Page

Step 6

Caution

proper ﬂow of cooling air through the chassis.

Step 7

Step 8

Step 9

Removing a Power Supply

Replacing the card cage and backplane assembly ﬁrst requires you to remove power supplies (and

the power supply blank if one is installed, in a system with one power supply), and then replace them

after the new card cage assembly is in place.

Follow these steps to remove a power supply.

Step 1

Step 2

Step 3

Using your thumbs, simultaneously push both ejector levers inward until they push the

processor module completely into the slot. The ejector levers should be in approximately

the same orientation as the processor module faceplate. (See Figure 3c.)

Always install blank processor module ﬁllers in empty processor slots to maintain the

Use a screwdriver to tighten both captive installation screws on each processor module.

Attach network interface cables or other devices to the interface ports. Use the notes you

made in the slot and port worksheet in Table 1.

After you reconnect power and turn ON power, check the status of the interfaces as follows:

•

Use the show interface [type] or show controller [type] command to verify that the

system has acknowledged the interfaces and brought them up.

•

Use the conﬁgure command or the setup command facility to conﬁgure any new

interface(s) you might have installed. This does not have to be done immediately, but

the interfaces will not be available until you conﬁgure them.

Turn OFF (O) the system power switch on each power supply you plan to remove.

Disconnect the power supply cables from the power supplies.

For DC-input power supplies, refer to the conﬁguration note "1200-Watt DC-Input Power

Supply Replacement Instructions" (Document Number 78-1899-01) that shipped with the

Cisco 7513 chassis equipped with DC-input power supplies.

For AC-input power supplies, refer to the conﬁguration note "1200-Watt AC-Input Power

Supply Replacement Instructions" (Document Number 78-1900-01) that shipped with the

Cisco 7513 chassis equipped with AC-input power supplies.

Use a large slotted screwdriver to loosen the captive screw that secures the power supply to

the chassis frame. (See Figure 6.)

Cisco 7513 Card Cage and Backplane Assembly Replacement Instructions

Removing a Power Supply