Cisco AS5300 - Universal Access Server Configuration Manual - Page 15
Browse online or download pdf Configuration Manual for Server Cisco AS5300 - Universal Access Server. Cisco AS5300 - Universal Access Server 46 pages. Access server
Also for Cisco AS5300 - Universal Access Server: Appendix (10 pages), Quick Start Manual (25 pages), Manual (21 pages)
Print Page
Chapter 2
Configuring the Cisco AS5300 Network Access Server
To configure the serial channels, enter the following commands beginning in global configuration
mode:
Access the configuration mode for the D-channel serial interface that corresponds to controller T1 0.
Step 1
The behavior of B channels S0:0 through S0:22 is controlled by the configuration instructions provided
for S0:23. This concept is also true for the other remaining D-channel configurations.
hq-sanjose(config)# interface serial 0:23
Enable analog modem voice calls coming in over the B channels to be connected to the integrated
Step 2
modems.
hq-sanjose(config-if)# isdn incoming-voice modem
hq-sanjose(config-if)# no shutdown
Return to global configuration mode.
Step 3
hq-sanjose(config-if)# exit
Configure the three remaining D channels with the same settings.
Step 4
hq-sanjose(config)# interface serial 1:23
hq-sanjose(config-if)# isdn incoming-voice modem
hq-sanjose(config-if)# no shutdown
hq-sanjose(config-if)# exit
hq-sanjose(config)# interface serial 2:23
hq-sanjose(config-if)# isdn incoming-voice modem
hq-sanjose(config-if)# no shutdown
hq-sanjose(config-if)# exit
hq-sanjose(config)# interface serial 3:23
hq-sanjose(config-if)# isdn incoming-voice modem
hq-sanjose(config-if)# no shutdown
hq-sanjose(config-if)# exit
hq-sanjose(config)#
Verifying the Serial Channel Configuration
Enter the show interface serial 0:23 command to display the serial channel interface configuration.
Step 1
hq-sanjose# show interface serial 0:23
Serial0:23 is up, line protocol is up (spoofing)
Hardware is DSX1
MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set
DTR is pulsed for 1 seconds on reset
Last input 00:00:12, output 00:00:12, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations
0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
937 packets input, 19612 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 2 giants, 0 throttles
2 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
945 packets output, 4263 bytes, 0 underruns
0 output errors, 0 collisions, 4 interface resets
Task 2—Setting Up Asynchronous Shell Services
Cisco IOS Dial Services Quick Configuration Guide
2-15