Cisco SCE8000 GBE Quick Start Manual - Page 14

Browse online or download pdf Quick Start Manual for Server Cisco SCE8000 GBE. Cisco SCE8000 GBE 25 pages. 10gbe platform
Also for Cisco SCE8000 GBE: Configuration Manual (18 pages), Removal And Replacement Procedures (36 pages), Installing (21 pages)

Print Page

Figure 9

Cabling the Management Port

S C E 8 0 0 0

Connect the other end of the Ethernet cable into your management network. The Link LED on the SCE8000

Step 2

management port lights.

Test connectivity. From the host that you intend to use for remote management, ping to the Cisco SCE8000 by typing

Step 3

ping and the Cisco SCE8000 IP address, and pressing Enter.

This verifies that an active connection exists between the specified station and the management port.

This chapter describes cabling the Cisco SCE8000 10 Gigabit Ethernet ports for single, cascaded, and multigigabit service

control platforms (MGSCP) topologies.

The 10 Gigabit Ethernet ports are located on the 10 G SPA modules, which are installed in the SCE8000-SIP module in slot #3

of the Cisco SCE8000 chassis.

Warning

Class 1 laser. Avoid exposure to radiation and do not stare into open aperture.

SCE8000 Connectivity Summary

Table 3 through Table 7 summarize SCE 8000 connectivity for basic topologies. Receive-only topologies use only receive fibers.

You can implement receive-only topologies using either an optical splitter or a switch. If you use a switch, it must

Note

support SPAN functionality that includes separation between ingress and egress traffic and multiple SPAN-port

destinations.

Table 3

Single Link Connectivity

Port

Link

3/0/0

Link 0

3/1/0

Link 0

- S C M - E

O P T IC A

B Y P A S

S 1

C O N S O

L E

P O R T 1

1 0 /1 0 0 /

1 0 0 0

Side

Subscribers

Network

L IN K /

A C T IV E