Cisco SCE8000 GBE Removal And Replacement Procedures - Page 32
Browse online or download pdf Removal And Replacement Procedures for Server Cisco SCE8000 GBE. Cisco SCE8000 GBE 36 pages. 10gbe platform
Also for Cisco SCE8000 GBE: Quick Start Manual (25 pages), Configuration Manual (18 pages), Installing (21 pages)
Print Page
Installing a SPA in a SIP
Figure 9-17
Figure 9-17
Table 9-1
This number
1
2
Installing a SPA in a SIP
To install a SPA in a SIP, see
At the SCE# prompt, enter reload shutdown and press Enter to power down the Cisco SCE 8000
Step 1
platform before installing or removing any module.
To insert the SPA in the SIP, locate the guide rails inside the SIP that hold the SPA in place. They are at
Step 2
the top left and top right of the SPA slot and are recessed about an inch, as shown in
Carefully slide the SPA into the SIP until the SPA is firmly seated in the SPA interface connector. When
Step 3
fully seated, the SPA might be slightly behind the SIP faceplate.
After the SPA is properly seated, fasten the SPA in place with the captive installation screws.
Step 4
Cisco SCE8000 10GBE Installation and Configuration Guide
9-32
illustrates how to install and remove a SPA in the Cisco SCE 8000-SIP.
SPA Installation and Removal
76 00 -S
IP -40 0
SP A INT
ER FA CE
PR OC
ES SO R
SP A- 1X
10G E-L
-V2
SP A- 1X
10G E-L
-V2
2
Componet Indications
Figure 9-17
1
Indicates this component
Cisco SCE 8000-SIP
1X10 GBE SPA module
and do the following:
Chapter 9 Removal and Replacement Procedures
Figure
9-17.
OL-26784-02