B2 Audio SLD5K Owner's Manual - Page 5
Browse online or download pdf Owner's Manual for Amplifiers B2 Audio SLD5K. B2 Audio SLD5K 12 pages.
Print Page
Panel layout
sld5k
GND (GROUND CONNECTION)
Connects to the vehicle's chassis.
Keep as short as possible (< 20" / 50 cm)
Use minimum 0 Ga cable for optimal conditions.
REM (REMOTE)
Connects to switched +12V from the headunit.
speaker (speaker output)
Connects to the speaker(s) leads. Ensure polarity is correct
on the speaker and connect to the corresponding
output. NOTE, terminal is internally bridged and minimum
impedance is 1 ohm.
In STRAPPED mode, minimum load is 2 ohm.
Use high quality cable of at least 12 Ga.
Installation of the amplifier shall be done in the following steps:
1. Connect the +12V wire, keep in mind this wire has to be fused at the battery as well. 2. Ensure the ground is
appropriate, then connect it to the ampli er. 3. Connect the switched remote. 4. Reattach negative wire (ground)
to the battery. 5. Operation over 18 V will cause the ampli er to go into protect & can void the warranty!
GND
B+
POWER
500A (External fuse)
Head unit
REM
B+
GND
POWER
BATTERY
+ 12V (POWER CONNECTION)
Connects to the positive terminal of the battery.
For speci ed performance 0 Ga cable is required.
Fuses shall be placed within 8" / 20 cm of the battery.
The HI-EF class D design allows for higher output
power, even at low voltage applications.
This sets high requirements to the battery system.
Choose batteries with high CCA ratio.
CAUTION
5
GROUND*
* Keep ground as short as possible, no longer
than 20" (50 cm).