Cisco UCS B460 M4 Installation And Service Note - Page 45

Browse online or download pdf Installation And Service Note for Server Cisco UCS B460 M4. Cisco UCS B460 M4 50 pages. Blade server
Also for Cisco UCS B460 M4: Datasheet (7 pages), Installation And Service Note (46 pages), Quick Start Manual (2 pages), Quick Start Manual (5 pages)

Print Page

Upgrading to a Cisco UCS B460 M4 Blade Server

This chapter contains the following sections:

•

Upgrading to a Cisco UCS B460 M4 Blade Server

Before you begin

• Ensure that the UCS B260 M4 Blade Module is installed in slot 7 in the chassis. This module will the

• Ensure that the UCS B260 M4 Blade Module from the upgrade kit is installed in slot 5 in the chassis.

Note

The KVM cable, USB flash device, and the SD cards must be configured in the UCS B260 M4 Blade Module

installed in slot 7. These components only operate in the master blade.

The following procedure describes installing a UCS B460 M4 blade server in slots 7 and 5. Other slot

combinations can also be used, including slots 5 and 3, and slots 3 and 1. However, the heaviest blade server

in the chassis should be installed in the lowest slots so if only one UCS B460 M4 is to be installed, then it

should go in slots 7 and 5.

Procedure

Step 1

Remove the UCS Scalability Terminator from the UCS B260 M4 Blade Module installed in slot 7. See

Removing the Scalability Terminator, on page

Step 2

Install the UCS B260 M4 Blade Module from the upgrade kit into slot 5 if the module is not already installed.

Step 3

Use the UCS Scalability Connector to connect together the blade modules in slot 7 and slot 5. See

a Scalability Connector, on page

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v3 and E7 v2 CPUs

Upgrading to a Cisco UCS B460 M4 Blade Server, on page 37

Removing the Scalability Terminator, on page 38

Installing a Scalability Connector, on page 38

be master in the UCS B460 M4 blade server.

C H A P T E R

38.

Installing