Finders Super Fix Manual - Page 3
Browse online or download pdf Manual for Signal Processors Finders Super Fix. Finders Super Fix 7 pages.
Print Page38. Press and then release the TUNE control on the front panel to automatically reduce electrical
interference as normal.
39. Should the interference frequency be unstable and slowly changing, producing a slow beat
note, (this will cause Super Fix to give false signals) try to reset the TUNE control to a position
where a fast beat note is continually heard (Super Fix will then eliminate the interference).
Should you need to change to a higher beat note press the tune button to repeat the tune
sequence and listen to the frequency of the tune cycle on the threshold, when a faster frequency
is heard, switch the Master Power Switch on Super Fix to the center OFF position, wait a few
seconds and the switch back on again.
40. Set the IRON DISCRIMINATE switch on the front panel to All Metal.
41. Set the SOIL switch on the front panel to normal.
42. Set the RX switch to the Normal position.
43. Ground balance the detector as normal using the standard automatic ground balance procedure,
then switch the SEARCH control to the fixed position to operate.
44. Now go to section (C) Super Fix Settings
GP3000
45. Ensure that the M\LAB - S\FIX MODE switch situated on the top of Super Fix' s front face
panel is switched to the M\LAB position.
46. Switch the SPEAKER switch situated at the top of Super Fix' s rear face to the ON position.
47. Turn the POWER switch on the rear panel to the ON position
48. Set the BOOST switch on the rear panel to the normal position. Set the TONE control on your
Minelab detector to between a low position of (nine o' clock) to a maximum midway position
(twelve o' clock) tonal range.
49. Set the TONE control on your Minelab detector to the minimum low position
50. Set the THRESHOLD control on your Minelab detector to a midway (twelve o' clock) position.
51. Set the SIGNAL control on the rear panel to the maximum position.
52. Set the VOLUME control on the rear panel to maximum.
53. Now switch the MASTER POWER switch on Super Fix' s rear face panel to the SD/GP Mode.
Super Fix has a built in soft start feature which eliminates the normal loud burst of audio to
headphones and inbuilt speaker, and after initial power up you should now hear an audio output
from the speaker and also from your headphones if they are connected..
54. Press and then release the TUNE control on the front panel to automatically reduce electrical
interference as normal.
55. Should the interference frequency be unstable and slowly changing, producing a slow beat
note, (this will cause Super Fix to give false signals) try to reset the TUNE control to a position
where a fast beat note is continually heard (Super Fix will then eliminate the interference). ).
Should you need to change to a higher beat note press the tune button to repeat the tune
sequence and listen to the frequency of the tune cycle on the threshold, when a faster frequency
is heard, switch the Master Power Switch on Super Fix to the center OFF position, wait a few
seconds and the switch back on again.
56. Set the IRON DISCRIMINATE switch on the front panel to All Metal.
57. Set the SOIL switch on the front panel to normal.
58. Set the RX switch to the Normal position.
59. Ground balance the detector as normal using the standard automatic ground balance procedure.
Preferably if ground conditions permit switch the SEARCH control to the fixed position to
operate.
60. Now go to section (C) Super Fix Settings
GP3500
61. Ensure that the M\LAB - S\FIX MODE switch situated on the top of Super Fix' s front face
panel is switched to the M\LAB position.
62. Switch the SPEAKER switch situated at the top of Super Fix' s rear face to the ON position.
63. Turn the POWER switch on the rear panel to the ON position