Cisco UCS C220 M4 Upgrade Manual - Page 3
Browse online or download pdf Upgrade Manual for Server Cisco UCS C220 M4. Cisco UCS C220 M4 11 pages. For intel xeon v3 series cpus
Also for Cisco UCS C220 M4: Quick Start Manual (29 pages), Quick Start Manual (29 pages), Service Note (10 pages)
•
Click OK to initiate the low-level firmware update.
Step 4
When the low-level firmware update is finished, you can continue with replacing the hardware.
Initiating a Low-Level Firmware Update Using the Cisco IMC CLI interface
Step 1
Log in to the CLI interface for the server.
Enter the following commands and observe the message that is returned:
Step 2
# scope chassis/firmware
/chassis/firmware # show detail
•
•
Enter the following command:
Step 3
/chassis/firmware # update-all
Starting firmware update process, this will take a while. Check status using show command.
When the update is done, enter the following commands:
Step 4
/chassis/firmware # exit
/chassis # exit
The following is an example of these commands used in an update operation.
# scope chassis/firmware
/chassis/firmware # show detail
Firmware update required on some components, please run update-all (under chassis/firmware
scope).
/chassis/firmware # update-all
Starting firmware update process, this will take a while. Check status using show command
/chassis/firmware # show detail
Firmware update process is running, retry to get latest status.
...
/chassis/firmware # show detail
Firmware update completed
/chassis/firmware # show detail
Firmware update not required, all components are up to date
/chassis/firmware # exit
/chassis # exit
There is an update available for Chassis Firmware, would you like to continue?
If you do not see this dialog, all components are up-to-date and no further update is required.
If the return is
Firmware update not required, all components are up to date
If the return is
Firmware update required on some components, please run update-all
continue with the following step.
Cisco UCS C-Series Servers Upgrade Guide for Intel Xeon v3 Series CPUs
Minimum Software and Firmware Requirements
, skip to
Step
4.
,
3