Cisco UCS C240 Installation Manual - Page 13

Browse online or download pdf Installation Manual for Server Cisco UCS C240. Cisco UCS C240 22 pages. Connected safety and security (css)
Also for Cisco UCS C240: User Manual (22 pages)

Print Page

Chapter 2

Installing the Server

Press F5 to refresh the settings you made. You might have to wait about 45 seconds until the new settings

Step 14

appear and the message,

next step.

Step 15

Press F10 to save your settings and reboot the server.

Note

Connect to the CIMC for server management. Connect Ethernet cables from your LAN to the server by

Step 16

using the ports that you selected by your NIC Mode setting in

Active-passive NIC redundancy settings require you to connect to two ports.

Use a browser and the IP address of the CIMC to connect to the CIMC Setup Utility. The IP address is

Step 17

based upon the settings that you made in

DHCP server).

Note

To manage the server, see the Cisco UCS C-Series Rack-Mount Server Configuration Guide or the Cisco

UCS C-Series Rack-Mount Server CLI Configuration Guide for instructions on using those interfaces.

The links to these documents are in the C-Series documentation roadmap:

http://www.cisco.com/go/unifiedcomputing/c-series-doc

OL-25761-01

Network settings configured

If you chose to enable DHCP, the dynamically assigned IP and MAC addresses are displayed on

the console screen during bootup.

The default user name for the server is admin. The default password is password.

is displayed before you reboot the server in the

Step

Step 4

(either a static address or the address assigned by your

Cisco UCS C240 Server Installation and Service Guide

Initial Server Setup

4. The Active-active and

2-13