Cisco 2600 Series Appendix - Page 11

Browse online or download pdf Appendix for Gateway Cisco 2600 Series. Cisco 2600 Series 15 pages. Configuring adsl wic to support pppoe clients
Also for Cisco 2600 Series: Installation Manual (12 pages), Release Notes (32 pages), Configuration (15 pages), Application Note (41 pages), Datasheet (6 pages), Installation Manual (22 pages), Overview (13 pages), Quick Start Manual (2 pages), Manual (5 pages)

Print Page
Cisco 2600 Series Appendix
Caller ID on Cisco 2600 and 3600 Series Routers and Cisco MC3810 Multiservice Concentrators
Command
Step 4
Router(config-voiceport)# caller-id alerting
dsp-pre-alloc
Step 5
Router(config-voiceport)# caller-id alerting pre-ring
Caller ID Configuration Task List
Purpose
(FXO ports, only when caller-ID alerting
line-reversal is required) Configure this command
on the FXO port when the incoming subscriber
telephone line uses line polarity reversal to signal
the start of caller-ID information transmission.
The Cisco FXO interface cannot detect
line-reversal alerting in the on-hook state. For this
reason, DSPs must be pre-allocated to serve the
Type 1 caller ID information when it arrives.
Preallocating the DSPs enables the DSP to
continuously monitor for the arrival of caller-ID
information.
(FXS ports only) Configure this setting only when
the attached telephone device requires the pre-ring
(immediate ring) method to signal the start of a
caller ID information. The command activates a
250-ms pre-ring.
Cisco IOS Voice, Video, and Fax Configuration Guide
VC-821