Fine Art FINE 4019 PIXIE PLUS User Manual - Page 15

Browse online or download pdf User Manual for DJ Equipment Fine Art FINE 4019 PIXIE PLUS. Fine Art FINE 4019 PIXIE PLUS 16 pages.

Print Page

DMX connection

Note: The signal cable was type X connection.

Type X connection—if the external flexible cable or cord of this fixture is damaged, it

shall be replaced by a special cord or cord exclusively available from the manufact-

urer or his service agent.

3-pin or 5pin XLR connecters are provided for fixture DMX input and output. Pin 1 is

for earthing, pin 2 is for minus signals, and pin 3 is for plus signals. To prevent and

absorb the reflection and interference of the signals, each data link must be ended

by a respective terminator.

3-pin XLR connector

Connect the fixtures with Max.5 pieces. Make sure to insert the "signal in" terminal

in the last connecting fixture. shown in Figure8.3-2.

Note: Make sure the fixture vertically upwards when it is placed horizontally, the

safe distance between two adjacent fixtures must be ≥ 500mm.

Input

Controller

If long-distance data transfer occurs, a DMX512 signal amplifier is necessary. The

added amplifier is inserted between the lighting controller and the first fixture on the

basis of a normal data link.

Notice!

1. No more than one signal input or output can occur in one fixture.

2. Don't split a data link via output ports on the fixture, use a DMX512 signal amplifier instead,

if necessary.

3. Use only shielded-pair cables, and standard microphone cable is not reliable for

long-distance data transfer.

Pin1: GND

Pin2: Signal(-)

Pin3: Signal(+)

Fig.(8.3-1)

Input

Output

Fig.(8.3-2)

Terminator specification: a

120Ω plug-in resistor with

rated power of 0.25W,

soldered between pin 2 and

pin 3 at the end of respective

data link.

Output

- 14 -

Terminator

Input

Output

Terminator