Cisco ATA 188 Instructions For Installing - Page 2

Browse online or download pdf Instructions For Installing for Gateway Cisco ATA 188. Cisco ATA 188 6 pages. Analog telephone adaptor
Also for Cisco ATA 188: Configuration (28 pages), Overview (11 pages), Overview Manual (11 pages)

Print Page

What the Cisco ATA Package Includes

The plug-socket combination must be accessible at all times because it serves as the main

Warning

disconnecting device.

Do not work on the system or connect or disconnect cables during periods of lightning activity.

Warning

This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do

not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11

port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming

call.

For translated warnings, see the Regulatory Compliance and Safety Information for the Cisco ATA 186

and Cisco ATA 188 manual.

What the Cisco ATA Package Includes

The Cisco ATA package contains the following items:

•

Note

What You Need

You also need the following items:

•

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)

2-2

Cisco ATA 186 or Cisco ATA 188 Analog Telephone Adaptor

Read Me First - ATA Boot Load Information

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor at a Glance

Regulatory Compliance and Safety Information for the Cisco ATA 186 and Cisco ATA 188

5V power adaptor

Power cord

The Cisco ATA is intended for use only with the 5V DC power adaptor that comes with the unit.

Category-3 10BASE-T or 100BASE-T or better Ethernet cable. One cable is needed for each

Ethernet connection.

A Category-3 Ethernet cable supports 10BASE-T for up to 100 meters without quality degradation,

and a Category-3 Ethernet cable supports 100BASE-T for up to 10 meters without quality

degradation.

For uplink connections, use a crossover Ethernet cable to connect the Cisco ATA to another Ethernet

device (such as a router or PC) without using a hub. Otherwise, use straight-through Ethernet cables

for both uplink and data port connections.

Access to an IP network

One or two analog Touch-Tone telephones or fax machines, or one of each

Chapter 2

Installing the Cisco ATA

OL-4804-01