Cisco C1100TG-1N32A Hardware Installation Manual - Page 36

Browse online or download pdf Hardware Installation Manual for Gateway Cisco C1100TG-1N32A. Cisco C1100TG-1N32A 44 pages. Terminal gateway

Print Page

Connect to the Console Port with Mac OS X

This procedure describes how to connect a Mac OS X system USB port to the console using the built in OS

X Terminal utility.

Step 1

Use the Finder to go to Applications > Utilities > Terminal.

Step 2

Connect the OS X USB port to the router.

Step 3

Enter the following commands to find the OS X USB port number

Example:

macbook:user$ cd /dev

macbook:user$ ls -ltr /dev/*usb*

crw-rw-rw-

1 root

Step 4

Connect to the USB port with the following command followed by the router USB port speed

Example:

macbook:user$ screen /dev/tty.usbmodem1a21 9600

To disconnect the OS X USB console from the Terminal window

Enter Ctrl-a followed by Ctrl-\

This procedure shows how to connect a Linux system USB port to the console using the built in Linux Terminal

utility.

Step 1

Open the Linux Terminal window.

Step 2

Connect the Linux USB port to the router.

Step 3

Enter the following commands to find the Linux USB port number

Example:

Hardware Installation Guide for the Cisco 1100 Terminal Gateway

Use a ratcheting torque flathead screwdriver to torque the power

connector captive screws (above the installed wire leads) to 2

in-lb (0.23 N-m).

Insert the power connector to the mating connector on the rear

of the terminal gateway and tighten the two captive screws that

attach the connector to the terminal gateway.

Connect the other end of the positive wire to the positive

terminal on the DC power source and connect the other end of

the negative wire to the negative terminal on the DC power

source.

wheel

66 Apr

1 16:46 tty.usbmodem1a21 DT-macbook:dev user$

Install and Connect the Router