Acuity Brands Lithonia KAXW LED Installation Instructions - Page 3

Browse online or download pdf Installation Instructions for Outdoor Light Acuity Brands Lithonia KAXW LED. Acuity Brands Lithonia KAXW LED 4 pages.

Print Page

Installation Instructions

KAXW LED

CAUTION: APPLY A CONTINUOUS BEAD OF WEATHER-PROOF CAULKING BETWEEN MOUNTING PLATE AND WALL TO ENSURE

WEATHER-TIGHT INTEGRITY OF ELECTRICAL COMPONENTS.

Tools Required: Phillips Head Screwdriver, 5/32" Hex Key, 3/16" Hex Key

Onto a recessed 4" rectangular/octagonal J-Box (figure a)

figure a

Verify that supply power is off and that the j-box is securely mounted within the structural surface.

Remove both j-box fasteners from j-box (set aside for re-installation as needed).

Position KAXW wall mount plate over j-box feeding supply wires thru the center of the wall mount plate and slit in gas-

ket. Replace fasteners from step 2 (do not fully tighten).

Using a contractor level, ensure wall mount plate is level and fully tighten fasteners (use washers as required to ensure

a secure fit).

Over a recessed 4" rectangular/octagonal J-box via auxiliary mounting holes (figure a)

Verify that supply power is off . Using a contractor level, ensure wall mount plate is level and mark mounting surface

thru selected auxiliary mounting holes. Set the wall mount plate aside.

Drill holes as marked in step 1 and install appropriate mounting inserts capable of handling fixture load requirements.

Feed supply wires thru the center of the wall mount plate and slit in gasket.

Ensure wall mount plate is level. Fully tighten fasteners (use washers as required to ensure a secure fit).

figure b

DELIVERY: Upon receipt of fixture and accessories (packed separately), thoroughly inspect for any freight

damage. All damage should be reported to the delivery carrier. Compare the catalog description listed

on the packing slip with the fixture label on the inside of the housing to be sure you have received the

correct merchandise.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

4" recessed j-box

Wall mount plate

Auxillary mounting holes (8)

J-box fasteners/washers (2)

Supply wires

Housing

5. Position supply wires and

indicators

(2)

fixture wires in the downward

position. (figure b)

Wall mount

plate hooks

6. Tilting fixture slightly up-

(2)

ward, align fixture housing

indicators with wall mounting

Supply wires

plate hooks and slip fixture

back onto hooks. (figure b)

Part Number: RJ521397 Rev A

5 year limited warranty

Revision Date: 5/5/16