Cisco Physical Access CIAC-GW-K9 Installing And Configuring - Page 17
Browse online or download pdf Installing And Configuring for Gateway Cisco Physical Access CIAC-GW-K9. Cisco Physical Access CIAC-GW-K9 26 pages. Physical access gateway
Also for Cisco Physical Access CIAC-GW-K9: Quick Start Manual (17 pages)
Print Page
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
Figure 2-12
The web administration pages appear, and are described in the following sections.
Entering the Gateway Network Settings
Enter the network settings to enable IP communication between the Gateway and the Cisco PAM
appliance. Network settings include the following:
•
•
•
Tip
Gateway modules can be added to the IP network before or after the full module configuration is entered
in Cisco PAM. For more information, see the
Procedure
Complete the following steps for each Gateway in the system.
Enter the ETH0 Configuration settings, as shown in
Step 1
communications with the Cisco PAM appliance.
a.
b.
OL-32499-01
Login Screen for the Cisco Physical Access Gateway
ETH0 Configuration: the ETH0 port provides IP network connectivity with the Cisco PAM
appliance.
DNS Configuration: enter a DNS configuration if names (not IP addresses) are used for the NTP
or CPAM addresses.
Cisco PAM Configuration: defines the IP address and port of the Cisco PAM appliance that is used
to manage the Gateway.
If a Dynamic Host Configuration Protocol (DHCP) server is configured on your IP network, check
the DHCP box for ETH0 to automatically configure the required IP network settings, including IP
address, Subnet Mask, and Gateway. The DHCP check box is checked by default.
(Optional) If a DHCP server is not used to assign IP address settings, enter the following information
in the ETH0 fields:
IP address: Enter the IP address of the Cisco Physical Access Gateway.
–
Subnet Mask: Enter the subnet mask.
–
–
Gateway: Enter the IP gateway address.
Configuring and Managing the Gateway Using a Direct Connection
Cisco Physical Access Manager User
Figure
2-13. The ETH0 port is used for network
Cisco Physical Access Gateway User Guide
Guide.
2-17