Cisco Physical Access CIAC-GW-K9 Installing And Configuring - Page 7
Browse online or download pdf Installing And Configuring for Gateway Cisco Physical Access CIAC-GW-K9. Cisco Physical Access CIAC-GW-K9 26 pages. Physical access gateway
Also for Cisco Physical Access CIAC-GW-K9: Quick Start Manual (17 pages)
Print Page
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
Installing the Cisco Physical Access Gateway
•
•
Before You Begin
Before you install a Cisco Physical Access Gateway, verify the following:
•
•
Procedure
To install the Cisco Physical Access Gateway, perform the following procedure:
Mount the Gateway to a wall. See the
Step 1
for more information.
Step 2
Connect the Gateway to a power source.
•
•
See the
OL-32499-01
Before You Begin, page 2-7
Procedure, page 2-7
Verify that the module has access to a power source. See the
section on page 1-12
for more information.
Verify that you have the necessary mounting brackets or other hardware. See the
Gateway or Optional Module" section on page
If using a DC power source, insert a two-pin connector plug into the DC power port
and connect the Voltage In (VIN) and ground (GND) wires.
If using PoE, connect an Ethernet cable from the IP network to the ETH0 port
"Power Options and Requirements" section on page 1-12
Installing the Cisco Physical Access Gateway
1-14.
"Mounting a Gateway or Optional Module" section on page 1-14
Cisco Physical Access Gateway User Guide
"Power Options and Requirements"
"Mounting a
(Figure
(Figure
2-4).
for more information.
2-4),
2-7