Epson Perfection V350 Series User Manual - Page 7

Print Page

Ejecting Film

When you finish scanning, follow these steps to eject the film

from the auto film loader:

1. Press the 5 Eject button.

2. Remove the film after the Status light comes on.

Note:

Do not pull out the film. Wait until it is ejected automatically.

Do not turn off the scanner before ejecting film. If you do so

accidentally, turn on the scanner again and press the 5 Eject

button.

3. Flip the metal film guide back in and close the auto film

loader cover.

Note:

If the Status light is flashing red, your film may have jammed.

When you are finished scanning film, be sure to replace the

document mat before scanning documents or photos. See

page 8.

Placing Slides in the Holder

You can scan two 35 mm slides at a time using the slide portion

of the film holder.

Note:

Make sure the white stickers on the back of the film holder and the

areas around them are not scratched, dusty, or covered in any way. If

the areas are obscured, the scanner may have trouble recognizing

your slides in Full Auto Mode.

Do not cover the small holes on the film holder.

1. Place the film holder on the document table so that it is

aligned as shown. Make sure the tab labeled

holder fits into the area labeled

2. Place one or two slides in the film holder with the shiny

base side facing down. Your images should appear

backwards on the side that faces up. Your images should be

oriented as shown.

Note:

Make sure you place the long edge of the slide in the film holder

as shown above, for both landscape and portrait-oriented photos.

3. Close the scanner cover.

When you are finished scanning slides, be sure to replace the

document mat before scanning documents or photos. See

page 8.

8/06

Epson Perfection V350 Photo

on the film

on the scanner.

Epson Perfection V350 Photo - 7