Cisco Small Business SPA8800 Quick Start Manual
Browse online or download pdf Quick Start Manual for Gateway Cisco Small Business SPA8800. Cisco Small Business SPA8800 2 pages. Small business pro
phone adapter with router
Also for Cisco Small Business SPA8800: Quick Start Manual (2 pages)
Print Page
Quick Start Guide
Cisco Small Business Pro
SPA8800 Phone Adapter with Router
Package Contents
• SPA8800 Analog Telephone Adapter with Router
• Power Adapter
• RJ-45 Ethernet Cable
• RJ-11 Phone Cables (4)
• Quick Start Guide
1
Before You Begin
The following basic services and equipment are required:
• An Integrated Access Device or modem for broadband access to the
Internet
• A computer with Microsoft Windows XP or Windows Vista for system
configuration
• An analog phone for administrative use with the Interactive Voice Response
(IVR) system
• (Recommended) An Uninterruptible Power Source (UPS), to ensure
continuous operation by providing continuous power to devices such as the
Integrated Access Device, switch, and router
2
Connect the Devices
N
If the SPA8800 is pre-configured by your ITSP, then you do
OTE
not need to change the default voice settings. Refer to the
documentation supplied by your service provider for more
information.
S
TEP
1
Power off your network devices, including your modem and PC.
S
2
Connect the phones to the SPA8800, by using one or both of the
TEP
following methods:
•
Connect an RJ-21 connector to the RJ-21 port (A).
Connector Pinouts Circuit
Pin (Ring)
Pin (Tip)
FXS 1
1
26
FXS 2
2
27
FXS 3
3
28
FXS 4
4
29
FXO 1
17
42
FXO 2
18
43
Connector Pinouts Circuit
Pin (Ring)
Pin (Tip)
FXO 3
19
44
FXO 4
20
45
•
If you are connecting individual phone lines, connect one end of an
RJ-11 phone cable to the PHONE 1 port (B). Connect the other end
of the cable to an analog phone.
•
Then connect other analog phones to the remaining PHONE ports
(C).
S
TEP
3
For access to the PSTN (Public Switched Telephone Network), connect
RJ-11 cables from the Line 1 to Line 4 FXO ports (D) to the RJ-11 wall
outlet for the telephone service.
S
4
Connect one end of an Ethernet cable to the Ethernet port (E). Connect
TEP
the other end of the cable to your cable/DSL modem.
S
TEP
5
Connect an one end of an Ethernet network cable to the AUX port (F).
Connect the other end of the cable to the Ethernet port of your PC.
S
6
Connect the included power adapter to the power port (G). Insert the
TEP
power adapter into an electrical outlet. The power LEDs on the front
panel are lit.
S
7
Power on your PC. Make sure the Ethernet adapter of the PC is set to
TEP
obtain an IP address automatically. For more information, refer to
Windows Help.
3
Setting Up the Network
Connection
N
If the SPA8800 is pre-configured by your ITSP, then you do
OTE
not need to change the default voice settings. Refer to the
documentation supplied by your service provider for more
information.
S
TEP
1
Start a web browser on your PC. In the Address bar, enter the
following address: 192.168.0.1/advanced
S
2
If the login screen appears, enter the user name and password that
TEP
were supplied by your ITSP. If your ITSP did not supply a password,
you will not see a login screen.
S
3
When the Router - Status screen appears, click the WAN Setup tab.
TEP