Cisco TelePresence ISDN GW MSE 8321 Getting Started Manual - Page 6

Browse online or download pdf Getting Started Manual for Gateway Cisco TelePresence ISDN GW MSE 8321. Cisco TelePresence ISDN GW MSE 8321 15 pages.
Also for Cisco TelePresence ISDN GW MSE 8321: Getting Started (17 pages)

Print Page

Cisco TelePresence ISDN GW MSE 8321 Getting Started Manual

Installing the

IMPORTANT

8000, and connecting the power supply, you must read the safety

information at

http://www.cisco.com/go/telepresence/safety

Although blades are hot-swappable parts, you must only remove one

blade at any time. Remove the power from the MSE 8000, if you need to

remove more than one blade at a time.

Before hot-swapping a blade, shut down the blade using the web

interface. Do not shut down a blade during a software upgrade or if the

blade is processing.

For information about powering the MSE 8000, see the Getting Started Guide on

http://www.cisco.com/en/US/products/ps11340/

prod_installation_guides_list.html

Step one: Install the ISDN GW MSE 8321 into the MSE 8000

chassis

You must install either a blade or a blanking blade in each of the ten

positions in the chassis.

The Cisco TelePresence Supervisor MSE 8050 (Supervisor) must be

installed into slot 1 of the MSE 8000 chassis.

Remove the blade or blanking blade from the slot into which you are going to

install the ISDN GW MSE 8321:

Using a No.1 Phillips screwdriver, loosen the screws in the retaining latches

with an anti-clockwise quarter turn.

Open both retaining latches on the front of the blade or blanking blade.

When open, a retaining latch is at a 90

the blade.

iii Slide out the blade or blanking blade.

Open both retaining latches on the front of the ISDN GW MSE 8321. When

open, a retaining latch is at a 90

ISDN GW MSE 8321

: Before installing the ISDN GW MSE 8321 into the MSE

angle perpendicular to the front of the blade.

Installing the ISDN GW MSE 8321

angle perpendicular to the front of