Cisco VG202XM Hardware Installation Manual - Page 33
Browse online or download pdf Hardware Installation Manual for Gateway Cisco VG202XM. Cisco VG202XM 48 pages. Voice gateways
Also for Cisco VG202XM: Quick Start Manual (19 pages)
Print Page
Chapter 3
Installing the Voice Gateway
Mounting the Chassis onto a Wall
The following warning applies only when the voice gateway chassis is mounted on a wall:
This unit is intended to be mounted on a wall. Please read the wall-mounting instructions carefully
Warning
before beginning installation. Failure to use the correct hardware or to follow the correct procedures
could result in a hazardous situation to people and damage to the system. Statement 248
You can mount the chassis onto a wall or other vertical surface by using the molded mounting-screw slots
on the bottom of the chassis and two number-six, 3/4 inch (M3.5 x 20 mm) screws. You must provide
the screws.
Figure 3-2
2
1
Before You Begin
Ensure that you meet the following conditions when you mount the chassis onto a wall:
•
•
•
OL-15959-01
Figure 3-2
shows the mounting-screw slots.
Mounting-Screw Slots for Mounting a Cisco VG202, Cisco VG202XM, Cisco VG204, or
Cisco VG204XM Voice Gateway Chassis onto a Wall
1
1
2
Rubber feet
The LEDs on the front panel face upward and are easily visible, because you will use the LEDs as
status and problem indicators.
The back panel faces downward, to reduce strain on the cable connections.
The power supply rests on a horizontal surface such as the floor or a table. If the power supply is
not supported, it can place strain on the power supply cable and cause it to disconnect from the
connector on the back panel of the chassis.
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Hardware Installation Guide
1
2
1
Mounting-screw slots
Mounting the Chassis onto a Wall
3-5