(3621 6W\OXV &;
If you don't see any improvement after cleaning three or four
times, check the solutions in the User's Guide. You can also turn
the EPSON Stylus CX3200 off and wait overnight—this allows
any dried ink to soften—and then try cleaning the print head
again.
Note:
When you don't turn on your EPSON Stylus CX3200 for a long time,
the print quality can decline. It's a good idea to turn on your Stylus
CX3200 at least once a month to maintain good print quality.
Replacing an Ink Cartridge
If the
light on the EPSON Stylus CX3200 is flashing and
Error
you see an ink low or ink out message on the LCD screen and
your computer monitor, you need to replace one of the
cartridges.
When a cartridge is more than six months old, you may need to
replace it if printouts don't look their best. If the quality doesn't
improve after cleaning and aligning the print head, you can
replace the cartridge.
Use these EPSON ink cartridges within six months of installing
them and before the expiration date on the package:
❏ Black ink cartridge: T040120
❏ Color ink cartridge: T041020
Caution:
To ensure good results, use genuine EPSON ink cartridges and do
not refill them. Other products may cause damage to your EPSON
Stylus CX3200 not covered by EPSON's warranty.
When you need new ink cartridges, contact your dealer, or call
the EPSON Store at (800) 873-7766 or visit
www.epsonstore.com (U.S. sales only). In Canada, please call
(800) 463-7766 for dealer referral.
Warning:
Keep ink cartridges out of the reach of children and do not drink the
ink.
If ink gets on your hands, wash them thoroughly with soap and
water. If ink gets in your eyes, flush them thoroughly with water.
Caution:
To avoid damaging the EPSON Stylus CX3200, never move the
print head by hand.
You cannot print if either ink cartridge is empty. Leave the empty
cartridge installed in the EPSON Stylus CX3200 until you have
obtained a replacement. Otherwise the ink remaining in the print
head nozzles may dry out.
(3621 6W\OXV &;
Removing and Installing Ink Cartridges
Be sure you have a new ink cartridge before you begin. Once
you start the ink cartridge replacement procedure, you must
complete all the steps in one session.
1. Make sure the EPSON Stylus CX3200 is turned on and not
printing. The control panel tells you which ink cartridge is
low or empty.
2. Press a
button until you see
Menu
press the
Color Copy
the replacement position.
3. Lift up the scanner.
4. Pull up the ink cartridge clamp. (The color cartridge is on
the right and the black is on the left.)
5. Lift the cartridge out of the EPSON Stylus CX3200 and
dispose of it carefully.
6. Unwrap the new ink cartridge. Then remove only the yellow
tape seal on top.
Change Cartridge
button. The ink cartridges move to
,
then
Print Page