Control Panel
load/eject button
paper
out light
black ink
out light
color ink
out light
reduce/
enlarge
button
Follow these guidelines when the control panel lights come on
or flash:
S
When the S paper out light flashes, paper is
jammed in the printer. Turn off the printer,
remove all the paper (including any pieces torn
off inside), then reload the stack. Turn on the
printer and press the E load/eject button.
When the S paper out light comes on, your
paper ran out or is incorrectly loaded. Load
paper in the feeder and then press the
E load/eject button.
B or A
When an ink out light flashes, your ink supply
is low. Make sure you have a replacement
cartridge.
When an ink out light comes on, you need to
replace the ink cartridge. See "Replacing an Ink
Cartridge" on page 8 for instructions.
When the scan/copy error light comes on, a
page or photo may be jammed in the scanner.
Turn off the power, open the top cover, and
remove the jammed document. Then close the
cover and turn the power back on.
P S B A When the P power and S paper out lights
flash and the B black and A color ink out
lights come on, jammed paper may be blocking
movement of the print head. Turn off the
printer, open the front cover, and remove any
paper. Then turn it back on.
When all the lights flash, your printer may have
an internal error. Turn off the power and make
sure you removed all the packing material.
Make sure there is enough space around the
rear vent. Then turn the power back on.
power light
power button
cleaning
button
scan/copy
error light
stop button
copy button
copy mode
button
9/99
Installing an Ink Cartridge for the First
Time
1. Plug the printer's power cord into a grounded outlet.
Caution:
Don't use an outlet that can be turned off by a wall switch or timer,
or one on the same circuit as a large appliance. This may disrupt the
power, which can erase the printer's memory or damage its power
supply.
2. Remove the ink cartridges from their packages. Then
remove only
only the yellow part of the tape seal on top as
only
only
shown.
black cartridge
Caution:
Use the ink cartridges packed with your printer the first time you
install them or your printer won't charge ink properly. You must
remove the yellow tape from the cartridge or you will permanently
damage it. Don't pull off the blue portion or try to remove the clear
seal from the bottom of the cartridge; ink will leak out.
3. Lower the printer's output tray and open the front cover.
4. Press the Ppower button to turn on the printer.The
Ppower light flashes and the B black and A color ink out
lights come on. The print head moves.
Caution:
Always use the power button to turn the printer on or off. Never
use an external switch, such as a power strip switch.
5. Lift up the color ink cartridge clamp.
EPSON Stylus Scan 2000
color cartridge
EPSON Stylus Scan 2000
- 5
Print Page