Digiway P550 Instruction Manual - Page 5

Browse online or download pdf Instruction Manual for Engine Digiway P550. Digiway P550 15 pages. Sliding gate motor
Also for Digiway P550: Instruction Manual (16 pages)

Print Page

CONTROL INPUIT AND BUTTON

Open (OPN) input & OPN push button

The OPN inputs are Push Button OPN and Terminal OPN input. Push OPN button or Activating

(connect OPN terminal to the COM (+12V)) the OPN input will start the gate to open. When gate

opened, if OPN is still activating, the gate will stay open.

Pedestrian Access (PED) input and Pedestrian (PED) push button

The pedestrian input partly opens gate.

CLS push button

The CLS push button on control board is to close gate.

OSC (open/stop/close) input and OSC push button

OSC input and OSC push button is for manual operation. Push to open the gate, push again stop gate,

another push closes the gate. When gate stopped by OSC input, auto close mode does not apply.

Photoelectric safety beam (PE) input. N/C type

If the P.E input activated while gate is closing, the gate will stop or reopen depending on the DIP

setting. If the gate in the opened position and P.E beam activated, the gate will stay in opened.

Encoder inputs

Encoder in mounted on the motor shaft. There is not service is required. 4 pins socket from encoder

directly plug in on the control board. Two plugs on the control board are for right hand or left hand

gate.

Drive signals (between control board and inverter)

Plug 1 link inverter and control board. This is five pins plug. Two pins for 12VDC supply from inverter

to control board and other three pins is from control board to inverter, open, close and running

frequency signals.

Lock output signal

Lock output relay has COM, N/C, N/O outputs. The output can be pause or presence set by DIP3.

Gate close (status) output signal

When gate in closed position the relay contact is on, this used to send closing signals to alarm system.

As long as the gate is not closed, the relay contact will be off and tell the alarm system, the gate is

open.

4. DIP SWICTH FUNCTION

SET/RUN (DIP1)

Dip1 ON selects setting mode. For E-code control and timers

DIP2 and DIP4

--- called "MOD0" ---E-code control with closed limit switch option

DIP2 off, DIP4 off

--- called "MOD1" ---E-code with one N/O limit switch

DIP2 off, DIP4 on

--- called" MOD3" ---F-code control with option two N/C limit switch

DIP2 on, DIP4 off

--- called "MOD4" ---F-code control with option one N/O limit switch

DIP2 on, DIP4 on

NOTE:

DIP2DIP4 SETTIGN MUST SUIT APPLICATION TYPE. THERE IS ONE AND ONLY

ONE IS RIGHT

LOCK Output (DIP3)

DIP3 ON selects lock output is pulse at every start cycle. DIP3 OFF selects lock output is presence.

The lock relay will be on if the gate is in opening and closing cycle. All other situations will be off.

PE trig close (DIP5)

DIP5 ON selects PE beam trig auto close mode. In this mode, if P.E beams trigged and clear the gate

will auto close after gate opened.

P750V5.0 industrial gate motor manual

ON=SET,

ON=F-code

ON= PLUSE

ON=PE CLS

OFF=RUN

OFF=E-code

OFF= PRESENCE

OFF=NO PE CLS