TomTom GO Professional 6250 Getting Started - Page 3
Browse online or download pdf Getting Started for GPS TomTom GO Professional 6250. TomTom GO Professional 6250 8 pages. Getting a gps signal on your navigation device
Print Page
To activate Traffic and Speed Cameras on your navigation device, do the following steps.
1. Make sure that
2. Make sure that your device has
driving view.
3. Make sure your device is fully charged. A low battery may prevent your device from receiving
TomTom Services.
4. Make sure that you're in a country with
5. For Smartphone Connected devices, make sure your phone is compatible and
navigation
device.
Note: TomTom Services are not available when your device is connected to your
computer.
6. If you see an error message when trying to use TomTom Services, do the following:
a. Select the Main Menu button
b. Make sure that the Traffic service subscription is valid and activated.
7. If you are still not able to access your services, reset your device to factory settings.
Note: Resetting your device removes all your saved places and settings, including the
language, the voice, and the warning settings.
a. Select the Main Menu button
Menu.
b. Scroll to the right of the screen and select the Settings
c. Scroll to the right of this menu and select System.
d. In the System menu, select Reset.
e. Select Reset again to confirm.
f.
A warning screen appears to confirm the deletion of your saved places and settings.
Select Reset to confirm.
Your device resets and restarts.
g. To sync with MyDrive, log in to your TomTom account in the TomTom Services menu on
your device.
8. If you still cannot see TomTom Services on your navigation device, wait one hour then try to
connect again.
My device is connected to the computer, but nothing
happens.
Click here to see which products/categories this applies to.
information sharing is enabled
a valid GPS
on your navigation device.
signal. You should see your current positon on the
TomTom Services
coverage.
then select TomTom Services.
in Map View or Guidance View to show the Main
connected to your
button.