Epson LQ-570+ Setup Manual - Page 3

Browse online or download pdf Setup Manual for Printer Accessories Epson LQ-570+. Epson LQ-570+ 14 pages. Sdx acd manager 5.2 printer setup
Also for Epson LQ-570+: Product Support Bulletin (20 pages), Product Support Bulletin (5 pages), Product Information Manual (8 pages), Install Manual (1 pages), Manual (12 pages), Specifications (2 pages), Manual (8 pages), Product Support Bulletin (16 pages), Service Manual (49 pages)

Print Page

Epson LQ-570+ Printer Operation

Printer Settings

Printer Setup Manual

SDX ACD Manager 5.2

The following pages give the basic information required for an ACD Manager user to

operate the printer supplied to produce reports.

Before any printing can take place the printer must be in the following condition:

1. The printer is loaded with paper.

2. The paper feed lever on the top right of the printer should be fully forward.

3. The printer is switched ON (if not press the Operate button).

4. The Power ON lamp is illuminated.

5. The Draft lamp is illuminated.

The printer is supplied setup to use Draft font which will give the quickest output and give

the longest ribbon life. The font can be changed by pressing the 'Font' button. The current

font will be shown by the adjacent indicator lamp.

The paper feed mechanism is supplied to use pull tractor feed. This method is

recommended as it gives least possibility of the paper jamming in the printer. This is

important as the ACD Autoprint normally takes place at night when the system is

unattended.

To enable the printer to operate correctly with the ACD Manager the DIP switches behind

the cover on the front of LQ-570+ printer should be set as shown below. These setting

switches should be changed when the printer is switched off, otherwise the new settings will

not be registered by the printer.

Epson LQ-570+ Printer Operation - Page 3

38DHB0002UKBP - Issue 1 (March 1999)

Introduction