Acuity Brands Lighting Lithonia Lighting HLF LED Installation Instructions Manual - Page 3

Browse online or download pdf Installation Instructions Manual for Lighting Equipment Acuity Brands Lighting Lithonia Lighting HLF LED. Acuity Brands Lighting Lithonia Lighting HLF LED 7 pages.

Print Page

Installation Instructions

HLF LED

DELIVERY: Upon receipt of fixture and accessories (packed sepa rately), thoroughly inspect for any freight damage.

All damage should be reported to the delivery carrier. Compare the catalog descrip tion listed on the packing slip with

the fixture label on the inside of the housing to be sure you have received the correct merchandise.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device

may not cause harmful interference, and (2) this device must accept any interference received, including interference

that may cause undesired operation.

HLF INTEGRAL SLIPFITTER (IS) INSTALLATION ON VERTICAL TENONS (+/- 5 °)

Note: Luminaire can be tilted up to 185 degrees (maximum) above horizontal.

Maximum tenon/pole diameter: 2" schedule 40 pipe (2-3/8" OD)

Tools Required:

• 9/64" Allen Wrench

• 3/16" Allen Wrench

• 3/8" Allen Wrench

NOTE: This luminaire is pre-wired with UL listed

supply wire leads. It is not necessary to access

fixture housing to install or wire the luminaire.

1. Remove the two (2) 8-32 splice wire access

cover fasteners from knuckle assembly, remove

the splice access cover, and pull supply wire leads

from knuckle cavity. CAUTION: Do not attempt

to pull additional length from the rotating junction

of the slipfitter. Doing so may damage the wires.

(See figure 2).

2. Slip luminaire knuckle fitter over 2-3/8" Ø pole

tenon and evenly tighten the six (6) 3/8-16 UNC

knuckle tenon set screws to 23-27 ft-lbs, while

maintaining the correct position of the luminaire

(see figure 1).

3. Cut and splice the wires. Recommended cut

length is 6" for wires for ease of splicing and secur-

ing in the knuckle.

4. Make all wiring connections via the supplied wire

leads in accordance with NEC and local codes.

5. Push all fixture and supply wires completely

within the knuckle cavity and replace the splice

access cover, gasket, and two (2) 8-32 splice ac-

cess cover fasteners. Torque the cover fasteners to

18-20 in-lbs.

Lithonia Lighting Outdoor • One Lithonia Way • Conyers, Georgia 30012

Phone: 800-279-8041 • Fax: 770.918.1209 •

www.lithonia.com

5 year limited warranty

Part Number: RJ521380 Rev C

Revision Date: 12-4-19