Epson Stylus Color 400 User Manual - Page 24

Browse online or download pdf User Manual for Printer Accessories Epson Stylus Color 400. Epson Stylus Color 400 29 pages. Ms windows 3.x color printer drivers problems
Also for Epson Stylus Color 400: Specification Sheet (2 pages), Product Information Sheet (4 pages), Manual (12 pages), Manual (13 pages), Quick Setup Manual (13 pages), Product Information Manual (12 pages), Product Support Bulletin (6 pages), Product Support Bulletin (4 pages)

Print Page

Disassembly and Assembly

3.2.4.7 Removing the Carriage Assembly

1. Remove the housing. (See Section 3.2.1.)

2. Loosen the timing belt by pushing the driven pulley holder, and remove the timing belt from the pulley on

the CR motor side.

3. Take the compression spring (19.6 g) out of the driven pulley holder.

4. Remove the driven pulley assembly from the driven pulley holder with the timing belt. Slide the driven

pulley holder and remove it from the frame.

5. Remove the torsion spring hanging on the frame and PG lever. Release the attached hook for the PG

lever and remove the lever.

6. Release the attached hook for the PG lever support, and remove the PG lever support and washer from

the edge of the CR guide shaft. (See the figure on the next page.)

7. Remove 1 screw (No. 7) and rotate the right parallelism adjustment bushing so that it fits into the notch

in the frame, and remove it.

8. Remove CR assembly with the CR guide shaft.

;

When disassembling the right parallelism adjustment bushing, mark the present location where the

bushing is fixed on the frame so that you can omit gap readjustment after assembly.

;

When installing the washer, pay attention to its direction. (The convex side should face the right

parallelism adjustment bushing side.) See the figure on the next page.

;

When installing the PG lever, see the figure below.

3-22

Figure 3-18. Installing the PG Lever

EPSON Stylus COLOR 400 Service Manual