Epson Stylus color 600 Manual - Page 5

Browse online or download pdf Manual for Printer Accessories Epson Stylus color 600. Epson Stylus color 600 19 pages. Epson stylus color 600: quick setup
Also for Epson Stylus color 600: User Manual (34 pages), User Manual (38 pages), User Manual (35 pages), Specifications (1 pages), Product Information Sheet (4 pages), Quick Setup Manual (17 pages)

Print Page

Initialization

The printer can be initialized (returned to a fixed set of

conditions) in these ways:

Hardware

The printer is turned on.

initialization

The printer receives an

interface.

Software

Software sends the ESC @ (initialize the printer)

initialization

command. The last panel settings are kept.

Hardware initialization

When the printer is turned on, the printer mechanism is

initialized, the input and print buffers are cleared, and all

settings return to their default values. However, the printer

mechanism is not initialized if the printer is turned on within

10 seconds after being turned off. In this case, the printer caps

the print head, and ejects any paper in the paper path.

Software initialization

Software initialization clears the print buffer and returns all

settings to their default values, as shown below.

Default Settings

The table below shows the default settings that take effect

when the printer is initialized.

Item

Default Setting

Top-of-form position

Current paper position

Page length

Single sheets: 22 inches

Left and right margins

Cancelled

Line spacing

1/6-inch line spacing

Character pitch

Last font selected using default-setting mode

Vertical tab position

Cleared

Horizontal tab

Every eight characters

positions

Font selection

Last font selected using default-setting mode

Special printing effects

Cancelled (except condensed and economy

printing)

User-defined

Hardware/control panel initialization: cleared

character set

Software initialization: deselected only

signal from the parallel

INIT

Built-in Fonts and Character Tables

Your printer has eight built-in fonts and eleven character

tables that you can select using the printer's default-setting

mode as described below. The setting you choose takes effect

each time you turn on the printer. Available fonts and

character tables are listed on pages 1 and 2.

Note:

The font and character table selections you make with

your software override the settings you make using the

default-setting mode. For best results, use your

software to make these settings.

To change the default font or character table, follow these

steps:

1. Make sure the printer is turned off and paper is loaded in

the sheet feeder. (Use paper at least 8.2 inches wide.

Otherwise the print heads will spray ink directly onto the

platen.)

2. Hold down the

The printer loads a sheet of paper and prints a brief

summary and instructions.

3. Follow the instructions on the sheet and press the

cleaning button until the control panel lights indicate

the language of your choice.

4. Press the

load/eject button to print the default font and

character table and the next page of instructions.

The instruction sheet lists all of the fonts and character

tables you can select.

5. Select the font and character table you want to use.

6. Exit the default setting mode by turning off the printer.

If you want to check the current default font and character

table, enter the default setting mode again and print the

current settings, which are indicated by arrows.

Note:

You may exit default setting mode any time by turning

off the printer. Any changes you made remain in effect

until you change them again.

1/97

EPSON Stylus COLOR 600

cleaning button and turn on the printer.

EPSON Stylus COLOR 600 - 5