Acuity Controls ECLYPSE A1000 Installation Manual - Page 9
Browse online or download pdf Installation Manual for Controller Acuity Controls ECLYPSE A1000. Acuity Controls ECLYPSE A1000 14 pages. Asset tracking
Also for Acuity Controls ECLYPSE A1000: Installation Manual (10 pages)
Print Page
5-0 Communications Wiring
Controllers are uniquely identified on the network by their MAC address.
This identifier is printed on a label located on the side of the controller and
on its shipping box. Get a printed copy of the building's floor plan. During
controller installation, peel the MAC address stickers off of the shipping box
and put it on the floor plan where the controller has been installed. This
MAC address is used as part of the controller's factory-default Wi-Fi access
point name and its network hostname.
There are two methods to connect to the controller: wired (Ethernet
connection) or wireless (when the ECLYPSE Wi-Fi Adapter is connected to
the controller).
5-1 Wired Connection
Network connections can be daisy-chained.
Connector
To Router /
Next IP Device
Figure 14: Communication Wiring
Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: 800.535.2465 www.acuitybrands.com © 2019 Acuity Brands Lighting, Inc. All rights reserved. Rev. 11/07/2019
Cat 5e
Network
RJ-45
Cable
To Next IP
Device
Bar Code
ID: MAC Address
Model: ECY-S1000
For example, for a MAC Address of : 76:a5:04:cd:4a:d1
The factory-default name for the Wi-Fi access point is ECLYPSE-CD4AD1
The factory-default hostname is eclypse-cd4ad1.local
Figure 13: Finding the Controller's MAC Address
5-2 Wi-Fi Connection
Connect the WiFi Adapter to one of the HOST connector of the server
module.
Once the ECLYPSE Wi-Fi Adapter has been connected to the controller, a Wi-
Fi hotspot becomes available that allows you to connect to the controller's
configuration Web interface with your PC.
On your PC's wireless networks, look for an access point named ECLYPSE-
XXYYZZ where XXYYZZ are the last 6 hexadecimal characters of the
controller's MAC address (see above). The default password for the wireless
network is: eclypse1234.
5-3 BLE Adapter Connection
Connect the BLE Adaptor to one of the HOST connectors of the server
module.
Label
9 of 14