Motorola MBP28BU Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Baby Monitor Motorola MBP28BU. Motorola MBP28BU 2 pages. Quick start guide

Print Page
1

Getting started

Step 1. Connecting the accessory camera
unit
DC SOCKET
DC PLUG
1. Insert the DC plug of the power adapter with the
smaller DC plug into the DC socket in the side of
the camera unit, as shown.
NOTE
Only use the enclosed power adapter (6V DC /
600mA).
2. Connect the other end of the power adapter to a
suitable mains socket or power outlet.
IMPORTANT
Use only the power adapter supplied with the product.
2
Help
For more solutions, see the full Help section in the User's Guide.
If the Camera Unit has lost link with the Parent Unit
• Check the electrical power and check whether the power adapter on the Camera Unit is connected firmly.
• If the Camera Unit is too far away, it may be going out of range, so move the Camera Unit closer to the
Parent Unit.
• Reset the units by disconnecting them from the battery and electrical power. Wait about 15 seconds before
reconnecting. Allow up to one minute for the Camera Unit and the Parent Unit to synchronize.
• See Step 2. Registration (Pairing), if there is a need to re-register the units.
3

General Information

If your product is not working properly...
1. Read this Quick Start Guide or the User's Guide.
2. Contact Customer Service:
1300 667 137 in Australia
Manufactured, distributed or sold by Binatone Electronics International LTD., official licensee for this
product. MOTOROLA and the Stylized M Logo are trademarks or registered trademarks of Motorola
Trademark Holdings, LLC. and are used under license. All other trademarks are the property of their
respective owners.
© 2012 Motorola Mobility, Inc. All rights reserved.
Step 2. Registration (Pairing)
To re-register your camera unit, or register a new
camera unit, follow the procedure below:
1
1. Press the
button of the parent unit to access
the main menu.
+
2. Press the
button or
REGISTER.
1
3. Press the
button to confirm. The parent unit
will display
Registration
Registering...
which indicates it has entered the
registration mode.
4. Press and hold the
until it emits a beep tone.
5. There will be a beep and the display will show
Registered
when the registration is successfully
completed, and the camera unit will be assigned a
baby unit number, which can be checked from the
parent unit.
AU EN
-
button to select
mode, and then display
>
button of the camera unit
Printed in China
Version 1.0