Motorola D1004 User Manual - Page 6
Browse online or download pdf User Manual for Cordless Telephone Motorola D1004. Motorola D1004 26 pages. Digital cordless phone
Also for Motorola D1004: User Manual (45 pages), User Manual (26 pages), User Manual (50 pages)
Print Page
3. Place the handset on the charger to charge for at least 24 hours. When the handset is fully
charged the
icon will indicate that it is fully charged.
4. When the handset is fully charged after 24 hours, plug the telephone line cord from the large
base into the telephone wall socket.
IMPORTANT
Warning! Use only rechargeable batteries. If non-rechargeable batteries are used WARNING BATT will
be displayed and charging will be stopped. Please replace with rechargable batteries.
BATTERY LOW WARNING
If the
icon flashes in the display, you will need to recharge the handset before you can use it
again.
During charging, the
icon will scroll in the display.
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give up to 10 hours talk time or up to 100 hours
standby time on a single charge.
Note that new batteries do not reach full capacity until they have been in normal use for several
days.
To keep your batteries in the best condition, leave the handset off the base for a few hours at a
time.
Running the batteries right down at least once a week will help them last as long as possible.
The charge capacity of rechargeable batteries will reduce with time as they wear out, giving the
handset less talk/standby time. Eventually they will need to be replaced.
After charging your handset for the first time, subsequent charging time is about 6–8 hours a day.
Batteries and handset may become warm during charging. This is normal.
6
Setting up your D1000
Welcome screen
m
1.
WELCOME
is displayed. Press
. The country name is shown on the display.
u
d
2. Scroll
or
to your country and press
3. Press
OK
to confirm.
The handset and base will reset to load the correct settings. The standby screen is then
displayed and your phone is ready to use.
You can still make and receive calls without first selecting your country and network operator,
however the Welcome screen will re-appear until you have configured your phone country
settings.
Date and time
Providing you have subscribed to your network's Caller Display service, the date and time is set
automatically for all handsets every time a call is received.
If you do not have a Caller Display service you can set the date and time manually.
Set date and time manually
m
d
1. Press
and scroll
to CLOCK/ALARM. Press
m
.
2. Enter the date using the format
DD/MM
e.g.
m
3. Press
and enter the time using the 24 hour format HH:MM,
e.g. 14:45 for 2:45pm.
m
>
4. Press
to confirm or
to return to standby.
Your D1000 is now ready for use.
m
.
CONFIRM?
is displayed.
m
. Display shows
DATE &
TIME, then press
04/ 08
for 4th August.
Getting started